SV01A103AEA01B00 Murata, SV01A103AEA01B00 Datasheet - Page 3

• Manufacturer Part Number: SV01A103AEA01B00
• Description: Board Mount Motion & Position Sensors 10K OHM SMD
• Manufacturer: Murata

Specifications of SV01A103AEA01B00

• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9
!Note
!Note
1. Store that the temperature is -10 to +40deg. C and
2. Do not store in or near corrosive gases.
3. Use within six months after delivery.
4. Open the package just before using.
5. Do not store under direct sunlight.
6. Do not use the rotary position sensor under the
1. Soldering
68
(1) PVS1 series can be soldered by reflow soldering
(2) The dimension of land pattern should be used
(3) Standard soldering condition
PVS1 Series Notice
Notice (Operating and Storage Conditions)
the relative humidity is 30-85%RH.
following environmental conditions. If you use the
rotary position sensor in an environment other
these listed below, please consult with Murata
factory representative prior to using.
Notice (Soldering and Mounting)
Reflow Soldering Standard Profile
method and soldering iron. Do not use flow
soldering method (dipping).
Murata's standard land pattern at reflow
soldering. Excessive land area may cause
displacement due to effect of the surface
tension of the solder. Insufficient land area
may cause insufficient soldering strength on PCB.
(a) Reflow soldering : Refer to the standard
(b) Soldering iron:
• Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specification or transact the approval sheet for product specification before ordering.
260
230
200
150
100
Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specification or to transact the approval sheet for product specificaion before ordering.
>Temperature of tip 360deg. C max.
>Soldering time
>Diameter
>Wattage of iron
0
Pre-heating in air
temperature profile.
60~120sec.
3mm max.
3sec. max./1 terminal
30W max.
(Melting zone)
40sec. Max.
Soldering
Gradual cooling
in air
Time
(5) The soldering iron should not come in contact
2. Cleaning
(1) Corrosive gasses atmosphere.
(2) In liquid.
(3) Dusty/dirty atmosphere.
(4) Direct sunlight.
(5) Static voltage nor electric/magnetic fields.
(6) Direct sea breeze.
(7) Other variations of the above.
(4) The amount of solder is critical. Insufficient
Can not be cleaned because of open construction.
with the cover of the rotary position sensor. If
such contact does occur, the rotary position
sensor may be damaged.
(Ex. Chlorine gas, Hydrogen sulfide gas, Ammonia
gas, Sulfuric acid gas, Nitric oxie gas, etc.)
(Ex. Water, Oil, Medical liquid, Organic solvent,
etc.)
Before using other soldering conditions than
those listed above, please consult with Murata
factory representative prior to using. If the
soldering conditions are not suitable, e.g.,
excessive time and/or excessive temperature,
the rotary position sensor may deviate from the
specified characteristics.
amounts of solder can lead to insufficient
soldering strength on PCB. Excessive amounts of
solder may cause the bridging between the
terminals.
R50E12.pdf 02.9.5