NCP21XW472J03RA Murata, NCP21XW472J03RA Datasheet - Page 35

• Manufacturer Part Number: NCP21XW472J03RA
• Description: Thermistors - NTC 4.7K OHM 5%
• Manufacturer: Murata
• Type: NTCr
• Series: NCPr

Specifications of NCP21XW472J03RA

• Resistance: 4.7 KOhms
• Tolerance: 5 %
• Termination Style: SMD/SMT
• Operating Temperature Range: - 40 C to + 125 C
• Lead Spacing: 1 mm
• Power Rating: 200 mW
• Package / Case: 0805
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
Please notice as shown below when you mount this product.
1. Do not melt the solder in resin head, when you solder
1. The ceramic element of this product is fragile, and
2. Do not apply an excessive force to the lead.
this product. If you melt the solder in resin head,
it has posibility that the break of wire, short and
break of lead insulation. In case you cut the lead
wire of this product less than 20mm from resin head,
the heat of melted solder at lead wire edge is
propagated easily to the resin head along the lead
wire.
care must be taken not to load an excessive
press-force or not to give a shock at handling.
Such forces may cause cracking or chipping.
Otherwise, it may cause junction between lead and
element to break or crack. Holding element by side
lead wire is recommended when lead wire is bent or
cut.
Notice (Soldering and Mounting) NXF Series
Notice (Handling)
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
for Temperature Sensor Thermo String Type/Lead Type !Caution/Notice
2. Do not touch the resin head directly by solder iron.
3. Do not separate the parallel lead wires 10mm or less
4. If you mold by resin this product, please evaluate
5. Do not bend the lead wire radius 1mm or less when
It may cause the melt of solder in resin head.
from theresin head, when you separate parallel lead
wires.
the qualityl of this product before you use it.
you bend the lead wire.
R44E.pdf
33
10.2.22
7