MXHS83QE3000 Murata Electronics North America, MXHS83QE3000 Datasheet - Page 29

• Manufacturer Part Number: MXHS83QE3000
• Description: TEST PROBE MANUL FOR MM8430-8130
• Manufacturer: Murata Electronics North America

Specifications of MXHS83QE3000

• Accessory Type: Measurement Probe
• Features: Locking
• For Use With/related Products: SWD and SWF Connectors
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 490-4982

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Usage Condition
(1) Do not apply electrical voltage greater than specified in
(2) Confirm product's performance is not influenced by
(3) Please contact the manufacturer beforehand, if the
2. Handling
(1) Avoid excessive stress when handling and transporting
(2) Do not try to pull the cable, when a connector with a
(3) Disregarding the following notes could cause
3. Handling Instructions
(1) Cable is designed to fit only with MM9329-2700
(2) Disengagement:
(3) Avoid twisting probe or cable when engaging or
(4) Mechanical stress:
Notice (Handling)
the drawing. It might cause degradation or destruction
of the product. Even if it endures during a short time,
long time qualification is not guaranteed.
contact of other components.
product is to be used in frequently bent position.
printed circuit board after connector and/or assembly
has been secured to PCB.
coaxial cable is handled.
mechanical damage and/or poor electrical performance.
receptacle. Any other receptacle cannot be used with
this cable.
Use tool P/N M22001 to insert or remove cable in a
vertical direction from receptacle. Avoid pulling only the
cable to prevent cable damage.
disengaging from connector.
The stress to the connector should be limited as shown
in Figure 1.
(a) Stress to the housing.
(b) Stress to the outer sleeve.
(c) Cable pull strength.
Continued from the preceding page.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Stress A and B: 5.0N max.
Stress C: 3.0N max.
Stress D: 2.0N max.
Stress E: 5.0N max.
Figure 1. Mechanical Stress after Engagement
A
B
C
D
E
Notice
O30E.pdf
27
07.9.3
4