CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 32

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

5.2 Using the J2/J3 Board-to-Board Connectors
The board-to-board connector should be a 1mm pitch one-piece part connector. The recom-
mended manufacture is Samtec with many connector options available; see section 5.2.1.1 and
5.2.1.2.
Chapter 2 contains more information about the connector and the electrical interface.
5.2.1 Suitable One-Piece Part Connectors
5.2.1.1 Single row connectors
These connectors are a single row connector and can be used if only J2 is needed.
This connector has a profile height of 1.65 mm and this has to be considered if components are
to be mounted on the motherboard under the OEM Serial Port Adapter board.
There are alignment pins on the bottom side of the connector.
The connector is available with M2 threaded inserts that fit the mounting holes on the board
(see section 5.1.2). You may screw the OEM Serial Port Adapter board directly into these inserts.
If you want to have a tighter and more secure mounting, you may use longer screws and secure
it using a nut on the backside of the motherboard.
Another way to mount the module is to use press-fit nuts on the motherboard and skip the M2
threads on the connector, see section 5.3 for more information about press-fit nuts.
Table 15: Single row connectors from Samtec.
NOTE:
When ordering connectors from Samtec or an official Samtec distributor, please use the ASP or-
der number and refer to the connectBlue global quote number for best price. For technical
questions regarding the Samtec connectors please contact connectBlue or Samtec at
([e-mail]).
See Figure 7 for more information about the connector and necessary measurements on the
motherboard. The large mounting holes on the motherboard are designed for press-fit nuts and
could be smaller if press-fit nuts are not used. The mounting holes are aligned with the outer
tangent of the 2.3mm mounting holes of the module (see section 5.1.2).
Samtec order
number
ASP-118645-01
ASP-118645-02
ASP-118579-01
ASP-118579-02
Quote
number
55392
55392
55392
55392
Version 1.16 - 2009-12
Equivalent part
SEI-120-02-GF-S-AB
SEI-120-02-GF-S-AB-TR
SEI-120-02-GF-S-M-AB
SEI-120-02-GF-S-M-AB-TR
Package
Tube
Tape-n-Reel
Tube
Tape-n-Reel
Remark
Align pin on bottom
side only
Align pin on bottom
side only
With M2 threaded
inserts and align pin on
bottom side only
With M2 threaded
inserts and align pin on
bottom side only
32