CS47048C-DQZ Cirrus Logic Inc, CS47048C-DQZ Datasheet - Page 38

• Manufacturer Part Number: CS47048C-DQZ
• Description: IC 4ch ADC 8ch DAC & Single Core 32-bit DSP Audio SoC (300M MACs)
• Manufacturer: Cirrus Logic Inc

Specifications of CS47048C-DQZ

• Operating Temperature Range: -40°C To +85°C
• No. Of Pins: 100
• Peak Reflow Compatible (260 C): Yes
• Frequency: 147MHz
• Embedded Interface Type: I2C, SPI
• Leaded Process Compatible: Yes
• Rohs Compliant: Yes
• Core Supply Voltage: 1.89V
• Digital Ic Case Style: LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CS470xx Data Sheet
Audio SOC Processor Family
10. Parameter Definitions
10.1 Dynamic Range
10.2 Total Harmonic Distortion + Noise
10.3 Frequency Response
10.4 Interchannel Isolation
10.5 Interchannel Gain Mismatch
10.6 Gain Error
10.7 Gain Drift
38
The ratio of the RMS value of the signal to the RMS sum of all other spectral components over the
The ratio of the RMS value of the signal to the RMS sum of all other spectral components over the
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude
A measure of crosstalk between the left and right channels. Measured for each channel at the
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
specified bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified
bandwidth made with a -60 dBFS signal. 60 dB is added to resulting measurement to refer the
measurement to full-scale. This technique ensures that the distortion components are below the
noise level and do not affect the measurement. This measurement technique has been accepted
by the Audio Engineering Society, AES17-1991, and the Electronic Industries Association of
Japan, EIAJ CP-307. Expressed in decibels.
specified bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in
decibels. Measured at -1 and -20 dBFS as suggested in AES17-1991 Annex A.
response at 1 kHz. Units in decibels.
converter's output with no signal to the input under test and a full-scale signal applied to the other
channel. Units in decibels.
Copyright 2011 Cirrus Logic
DS787PP5