LM2672M-5.0 National Semiconductor, LM2672M-5.0 Datasheet - Page 18

• Manufacturer Part Number: LM2672M-5.0
• Description: DC/DC Converter IC
• Manufacturer: National Semiconductor

Specifications of LM2672M-5.0

• Input Voltage: 40V
• Output Current: 1A
• Output Voltage: 5V
• No. Of Pins: 8
• Mounting Type: Surface Mount
• Voltage Regulator Type: Buck Switching
• Supply Voltage Min: 6.5V
• Output Current Max: 1A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

www.national.com
B. Select an appropriate capacitor value and voltage rating, using
the capacitor code, from the output capacitor selection table in
Figure 17. There are two solid tantalum (surface mount) capacitor
manufacturers and four electrolytic (through hole) capacitor
manufacturers to choose from. It is recommended that both the
manufacturers and the manufacturer's series that are listed in the
table be used. A table listing the manufacturers' phone numbers is
located in Figure 11.
4. Catch Diode Selection (D1)
A. In normal operation, the average current of the catch diode is
the load current times the catch diode duty cycle, 1-D (D is the
switch duty cycle, which is approximately V
value of the catch diode average current occurs at the maximum
input voltage (minimum D). For normal operation, the catch diode
current rating must be at least 1.3 times greater than its maximum
average current. However, if the power supply design must
withstand a continuous output short, the diode should have a
current rating greater than the maximum current limit of the
LM2672. The most stressful condition for this diode is a shorted
output condition.
B. The reverse voltage rating of the diode should be at least 1.25
times the maximum input voltage.
C. Because of their fast switching speed and low forward voltage
drop, Schottky diodes provide the best performance and efficiency.
The Schottky diode must be located close to the LM2672 using
short leads and short printed circuit traces.
PROCEDURE (Adjustable Output Voltage Version)
OUT
/V
IN
). The largest
18
B. From the output capacitor selection table in Figure 17, choose
a capacitor value (and voltage rating) that intersects the capacitor
code(s) selected in section A, C20.
The capacitance and voltage rating values corresponding to the
capacitor code C20 are the:
Surface Mount:
33 μF/25V Sprague 594D Series.
33 μF/25V AVX TPS Series.
Through Hole:
33 μF/25V Sanyo OS-CON SC Series.
120 μF/35V Sanyo MV-GX Series.
120 μF/35V Nichicon PL Series.
120 μF/35V Panasonic HFQ Series.
Other manufacturers or other types of capacitors may also be used,
provided the capacitor specifications (especially the 100 kHz ESR)
closely match the characteristics of the capacitors listed in the
output capacitor table. Refer to the capacitor manufacturers' data
sheet for this information.
4. Catch Diode Selection (D1)
A. Refer to the table shown in Figure 12. Schottky diodes provide
the best performance, and in this example a 1A, 40V Schottky diode
would be a good choice. If the circuit must withstand a continuous
shorted output, a higher current (at least 2.2A) Schottky diode is
recommended.
EXAMPLE (Adjustable Output Voltage Version)