LM6181IM-8 National Semiconductor, LM6181IM-8 Datasheet - Page 23

• Manufacturer Part Number: LM6181IM-8
• Description: Operational Amplifier (Op-Amp) IC
• Manufacturer: National Semiconductor

Specifications of LM6181IM-8

• No. Of Amplifiers: 1
• Bandwidth: 100MHz
• No. Of Pins: 8
• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Mounting Type: Surface Mount
• Package / Case: 8-NSOIC
• Number Of Channels: 1
• Common Mode Rejection Ratio (min): 50 dB
• Input Offset Voltage: 3 mV at +/- 5 V
• Operating Supply Voltage: 9 V, 12 V, 15 V, 18 V, 24 V, 28 V
• Supply Current: 8.5 mA at +/- 5 V
• Maximum Operating Temperature: + 85 C
• Maximum Dual Supply Voltage: +/- 16 V
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Typical Applications
CAPACITIVE FEEDBACK
For voltage feedback amplifiers it is quite common to place a
small lead compensation capacitor in parallel with feedback
resistance, R
plifier’s peaking in the frequency domain which equivalently
tames the transient response. To limit the bandwidth of
current feedback amplifiers, do not use a capacitor across
R
loop reduces the amplifier’s stability. Instead, reduced peak-
ing in the frequency response, and bandwidth limiting can be
accomplished by adding an RC circuit, as illustrated in Fig-
ure 7b.
f
. The dynamic impedance of capacitors in the feedback
and R
and Improve Pulse Response Characteristics.
Provides Higher Fidelity Pulse Response. R
S
FIGURE 6. Resistive Isolation of C
Could Be Increased to Maintain A
f
. This compensation serves to reduce the am-
6a
6b
(Continued)
L
V
01132820
= −1
01132821
f
23
Typical Performance
Characteristics
OVERDRIVE RECOVERY
When the output or input voltage range of a high speed
amplifier is exceeded, the amplifier must recover from an
overdrive condition. The typical recovery times for open-
loop, closed-loop, and input common-mode voltage range
overdrive conditions are illustrated in Figures 9, 11, 11, 12
respectively.
The open-loop circuit of Figure 8 generates an overdrive
response by allowing the
input range of the amplifier. Typical positive and negative
overdrive recovery times shown in Figure 9 are 5 ns and
25 ns, respectively.
Peaking in the Resulting Pulse Response
Bandwidth to 50 MHz, Eliminating
FIGURE 7. RC Limits Amplifier
±
0.5V input to exceed the linear
7a
7b
www.national.com
01132822
01132823