KN-COPD-3-UK KIDDE, KN-COPD-3-UK Datasheet - Page 9

• Manufacturer Part Number: KN-COPD-3-UK
• Description: ALARM, CARBON MONOXIDE, UK
• Manufacturer: KIDDE

2520-7203-00.qxd
Do not install this alarm to a switch- or dimmer-controlled outlet if pos-
sible.
Do not install in areas where the temperature is colder than 4.4°C
(40°F) or hotter than 37.8°C (100°F). These areas include uncondi-
tioned crawl spaces, attics, porches and garages. Extreme tempera-
tures will affect the sensitivity of the alarm.
Do not install this unit near deep cell large batteries. Large batteries
have emissions that can cause the alarm to perform at less than opti-
mum performance.
Avoid the following:
How to Install Your CO Alarm
Your Kidde CO Alarm with its removable adapter allows you to install
the alarm as a wall mounted unit, a direct plug unit, or as a table top
unit.
Refer to Where to Install Your CO Alarm for general guidelines.
7
Installation
• Excessive spillage or reverse venting of fuel burning appliances
• Extended operation of unvented fuel burning devices (range, oven,
• Temperature inversions that can trap exhaust gasses near the
• Car idling in an open or closed attached garage, or near a home.
caused by outdoor ambient conditions, such as:
1) Wind direction and/or velocity, including high gusts of wind.
2) Negative pressure differential resulting from the use of exhaust
3) Simultaneous operation of several fuel burning appliances com-
4) Vent pipe connections vibrating loose from a clothes drier, fur-
5) Obstructions in or unconventional vent pipe designs which can
fireplace, etc.).
ground.
Heavy air in the vent pipes (cold/humid air with extended periods
between cycles).
fans.
peting for limited internal air.
nace or water heater.
amplify the above situations.
2006.4.7
3:50 PM
Page 7