4432-DKDB1 Silicon Laboratories Inc, 4432-DKDB1 Datasheet - Page 45

• Manufacturer Part Number: 4432-DKDB1
• Description: WiFi / 802.11 Modules & Development Tools Tx/Rx Split 4432 TRx Testcard Hi band
• Manufacturer: Silicon Laboratories Inc

Specifications of 4432-DKDB1

• Modulation: GFSK
• Operating Voltage: 3.3 V
• Antenna: SMA
• For Use With/related Products: Si4432
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8.1.1. Basic Code Overview
Main ()
Hardware Initialization
RF chip in continuous receive mode
MCU hardware, system clock setup, and I/O init
Check incoming data for valet packet
Response to Push button command
Hardware SPI pin definition
SPI read/write function protocol
i.e.,
Hardware SPI setup
nSEL and nIRQ pin setup
SPI read/write functions
i.e.,
RF chip hardware and I/O init
RF Parameters definition
i.e.,
RF hardware setup and parameters setting
i.e.,
Blink LED for valid packet
Send Data Packet out
//define the default radio frequency
#define FREQ_BAND_SELECT 0x75
#define NOMINAL_CAR_FREQ1 0xBB
#define NOMINAL_CAR_FREQ2 0x80
#define SYSCLK
#define SPI_CLOCK
//RF chip
SBIT(RF_NSEL_PIN, SFR_P1, 3);
SBIT(RF_NIRQ_PIN, SFR_P0, 6);
//SPI port
SBIT(SPI_MISO_PIN, SFR_P1, 1);
SBIT(SPI_MOSI_PIN, SFR_P1, 2);
SBIT(SPI_SCK_PIN, SFR_P1, 0);
void SetHwMasterSpi(void)
{
// set frequency
SpiRfWriteAddressData((REG_WRITE | FrequencyBandSelect), FREQ_BAND_SELECT);
SpiRfWriteAddressData((REG_WRITE | NominalCarrierFrequency1), NOMINAL_CAR_FREQ1);
SpiRfWriteAddressData((REG_WRITE | NominalCarrierFrequency0), NOMINAL_CAR_FREQ2);
SPI1CFG = 0x40;
SPI1CN
SPI1CKR = (SYSCLK/(2*SPI_CLOCK))-1;
SPI1EN
//set nSEL pins to high
RF_NSEL_PIN = 1;
}
nSEL and nIRQ pin definition
= 0x00;
= 1;
(16000000L/2)
(SYSCLK/4)
Rev. 0.4
(main.c)
(C8051.h)
(C8051.c)
//Master SPI, CKPHA=0, CKPOL=0
//3-wire Single Master, SPI enabled
// Enable SPI1 module
(Si4432.h)
//frequency band select
//default carrier frequency: 915 MHz
(Si4432.c)
(main.c)
SDBC-DK3 UG
45