SNDJ-T4C-G01 Honeywell Sensing and Control, SNDJ-T4C-G01 Datasheet - Page 2

• Manufacturer Part Number: SNDJ-T4C-G01
• Description: DUAL HALL SENSOR
• Manufacturer: Honeywell Sensing and Control
• Series: SNDJr
• Type: Hall Effectr

Specifications of SNDJ-T4C-G01

• Output Type: Digital
• Actuator Material: Ferrous Metals, Gear Tooth
• Termination Style: Connector
• Frequency: 15kHz
• Voltage - Supply: 11 V ~ 32 V
• Must Operate: *
• Must Release: *
• Function: *
• Package / Case: Barrel, Stainless Steel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 480-2823

T4C Series
SENSOR SPECIFICATIONS
Characteristic
Supply voltage
Current consumption
Signal outputs
Frequency range
Insulation
Operating temperature
Housing
Cable/connector
Protection class
Vibration immunity
Shock immunity
Weight
Air gap
Pole wheel
NOTICE
INSTALLATION INFORMATION
•
•
•
2
The sensor wires must be laid as far as possible from
large electrical machines. They must not run parallel with
power cables. The maximum permissible cable length is
20 m [65 ft].
The sensor should be mounted with the middle of the face
side over the middle of the pole wheel. Where the pole
wheel has teeth or slots and with radial sensor location,
the sensor would normally be mounted over the center.
Dependent upon the wheel width, a degree of axial
movement is permissible.
A solid and vibration-free mounting of the sensor is
important.
www.honeywell.com/sensing
Parameter
11 Vdc to 32 Vdc
20 mA max. (without load)
1 square wave and 1 direction signal
Open collector outputs with 10 kOhm pull-up; Imax = -20 mA
The sensor is able to drive the coil of a relay by using a simple current limiting resistor. No
additional protection against voltage peaks is needed. Limit values: Isink <70 mA, L <800 mH
0 Hz to 15 kHz
Housing, cable shield, and electronic galvanically isolated (500 V/50 Hz/1 min.)
-20 °C to 100 °C [-4 °F to 212 °F]
Stainless steel 1.4305.
Max. allowable pressure applied to the front face: 100 bar
S variant: with cable PUR, four wires 0.34 mm
C variant: with connector 4 pins/M12 standard
Sensor head IP68, cable/entrance IP67, connector IP68 (mated)
30 g in the range of 5 Hz to 2000 Hz
50 g during 20 ms, half-sine wave
~120 g, including 1 m cable
For pole wheel M1 (DP 25,4): 0,1 mm to 0,5 mm [0.004 in to 0.02 in]
For pole wheel M2 (DP 12,7): 0,1 mm to 1,5 mm [0.004 in to 0.06 in]
Ferromagnetic toothed wheel, i.e. B. Ust37-2, type 1018 CRS, preferred involute gear form
Module >(DP 25,4 [1.0 in]), min. tooth width 10 mm [0.4 in], side offset with min. tooth width:
<0,2 mm [0.008 in], eccentricity <0,2 mm [0.008 in].
2
, AWG 22