PIC12LF1822T-I/SN Microchip Technology, PIC12LF1822T-I/SN Datasheet - Page 223

• Manufacturer Part Number: PIC12LF1822T-I/SN
• Description: 3.5 KB Flash, 128 Bytes RAM, 32 MHz Int. Osc, 6 I/0, Enhanced Mid Range Core, Na
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 12Fr

Specifications of PIC12LF1822T-I/SN

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 32MHz
• Connectivity: I²C, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 6
• Program Memory Size: 3.5KB (2K x 14)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Processor Series: PIC12LF
• Core: PIC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

24.4.6
In Single Output mode, PWM steering allows any of the
PWM pins to be the modulated signal. Additionally, the
same PWM signal can be simultaneously available on
multiple pins.
Once
(CCP1M<3:2> = 11
CCP1CON register), the user firmware can bring out
the same PWM signal to one, two, three or four output
pins by setting the appropriate STR1 bits of the
PSTR1CON register, as shown in
While the PWM Steering mode is active, the
CCP1M<1:0> bits of the CCP1CON register determine
the polarity of the output pins.
The PWM auto-shutdown operation also applies to
PWM Steering mode as described in
“Enhanced PWM Auto-shutdown
shutdown event will only affect pins that have PWM
outputs enabled.
 2010 Microchip Technology Inc.
Note:
the
PWM STEERING MODE
The associated TRIS bits must be set to
output (‘0’) to enable the pin output driver
in order to see the PWM signal on the pin.
Single
and
Output
P1M<1:0> = 00
mode
Table
mode”. An auto-
PIC12F/LF1822/PIC16F/LF1823
Section 24.4.3
24-9.
is
selected
of
Preliminary
the
FIGURE 24-18:
Note 1: Port outputs are configured as shown when
PORT Data
PORT Data
PORT Data
PORT Data
P1A Signal
CCP1M1
CCP1M0
CCP1M1
CCP1M0
2: Single PWM output requires setting at least
3: PIC16F/LF1823 only.
STR1C
STR1D
STR1A
STR1B
the CCP1CON register bits P1M<1:0> = 00
and CCP1M<3:2> = 11.
one of the STR1 bits.
SIMPLIFIED STEERING
BLOCK DIAGRAM
1
0
1
0
1
0
1
0
TRIS
TRIS
TRIS
TRIS
DS41413B-page 223
P1B pin
P1C pin
P1D pin
P1A pin
(3)
(3)