LTC1066-1CS Linear Technology, LTC1066-1CS Datasheet - Page 8

• Manufacturer Part Number: LTC1066-1CS
• Manufacturer: Linear Technology

Specifications of LTC1066-1CS

• Architecture: Switched Capacitor
• Order Filter (max): 8th
• Single Supply Voltage (typ): 5/9/12/15V
• Dual Supply Voltage (typ): ±3/±5V
• Power Supply Requirement: Single/Dual
• Single Supply Voltage (min): 4.75V
• Single Supply Voltage (max): 16V
• Dual Supply Voltage (min): ±2.375V
• Dual Supply Voltage (max): ±8V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Operating Temperature Classification: Commercial
• Filter Type: Low Pass Filter
• Lead Free Status / RoHS Status: Not Compliant

PIN
LTC1066-1
(see Block Diagram). Input bias current flows out of pins
2 and 3. Pin 16 (+IN B) is the positive input of a high
performance op amp B which is internally connected as
a unity-gain follower. Op amp B buffers the switched-
capacitor network output. The input capacitance of both
op amps is 10pF.
Pin 14 (FILTER
network. The input impedance of pin 14 is typically 11k.
Output Pins (1, 7, 17)
Pins 1 and 17 are the outputs of the internal high perfor-
mance op amps A and B. Pin 1 is usually connected to the
internal switched-capacitor filter network input pin 14.
Pin 17 is the buffered output of the filter and it can drive
loads as heavy as 200Ω (see THD + Noise curves under
Typical Performance Characteristics). Pin 7 is the internal
switched-capacitor network output and it can typically
sink or source 1mA.
Compensation Pins (11, 13)
Pins 11 and 13 are the AC compensation pins. If compen-
sation is needed, an external 30k resistor in series with a
8
U
FUNCTIONS
U
IN
) is the input of a switched-capacitor
U
15pF capacitor should be connected between pins 11 and
13. Compensation is recommended for the following
cases shown in Table 6.
Table 6. Cases Where an RC Compensation (15pF in Series with
30kΩ pins 11, 13) is Recommended, f
V
V
V
Connect Pins (6, 12)
Pin 6 (CONNECT 1) and pin 12 (CONNECT 2) should be
shorted. In a printed circuit board the connection should
be done under the IC package through a short trace
surrounded by the analog ground plane. Pin 6 should be
0.2 inches away from any other circuit trace.
S
S
S
= Single 5V (AGND = 2V)
= ±5V
= ±7.5V
T
T
T
T
T
T
A
A
A
A
A
A
= 25°C
= 70°C
= 25°C
= 70°C
= 25°C
= 70°C
CLK
/f
CUTOFF
f
f
f
f
f
f
CUTOFF
CUTOFF
CUTOFF
CUTOFF
CUTOFF
CUTOFF
= 50:1
≥ 28kHz
≥ 24kHz
≥ 60kHz
≥ 50kHz
≥ 70kHz
≥ 60kHz
10661fa