Z4A216C STEC, Z4A216C Datasheet - Page 65

• Manufacturer Part Number: Z4A216C
• Manufacturer: STEC
• Type: Solid State Driver

Specifications of Z4A216C

• Density: 16GByte
• Operating Supply Voltage (typ): 5V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Package Type: Not Required
• Mounting: Screw
• Pin Count: 44
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Programmable: Yes
• Lead Free Status / RoHS Status: Not Compliant

Zeus 2.5-Inch ATA Solid State Drive
System Requirements
The SSD can be installed in any system running an operating system that supports the ATA (IDE)
bus specification standard. No modifications to the operating system are required. The Zeus SSD
supports all ATA and ATAPI devices, including CDs, DVDs, tape backup devices, high-capacity
removable devices, Zip drives, and CDRWs.
If the drive is not recognized by the operating system, make sure the most recent drivers for the host
adapter are installed. If the drive is connected to the motherboard, the drivers are provided by the
motherboard manufacturer. If the drive is connected to a PCI card, contact the PCI card
manufacturer.
Before installing the Zeus SSD in the system, make sure the following items are available:
•
•
•
•
•
•
Phillips screwdriver
Six M3 UNC machine screws
ATA (IDE) bus interface cable (1 meter (39 inches) maximum length.
Mounting hardware (as required)
A computer with an ATA connector on the motherboard or an installed ATA host adapter
A 5.0V power source (4-pin connector)
(See Table 20 for the cabling requirements.)
ATA (IDE) Interface
44-pin; 44 conductor
44-pin, 80-conductor
There is a risk of electrocution! Use extreme caution when handling the
solid state drive and while connecting it to a power source. Observe all
applicable electrical safety rules while installing the solid state drive.
Make sure to read and thoroughly understand this section before
attempting to install the drive.
Table 20.
ATA (IDE) Cable Requirements
Operating Mode
PIO modes 0, 1, 2, 3 and 4
Ultra DMA Modes 0 - 5
Ultra DMA Modes 0 - 5
I
NSTALLATION
49