LM80CIMT-3 National Semiconductor, LM80CIMT-3 Datasheet - Page 11

• Manufacturer Part Number: LM80CIMT-3
• Manufacturer: National Semiconductor

Specifications of LM80CIMT-3

• Watchdog Timer: Yes
• Chip Enable Signals: No
• Package Type: TSSOP
• Operating Supply Voltage (min): 2.8V
• Operating Supply Voltage (max): 5.75V
• Operating Temp Range: -25C to 125C
• Operating Temperature Classification: Commercial
• Power Fail Detection: No
• Mounting: Surface Mount
• Pin Count: 24
• Battery Backup Switching: No
• Manual Reset: No
• Lead Free Status / RoHS Status: Not Compliant

The Serial Bus control lines consists of the SDA (serial data),
SCL (serial clock) and A0-A1 (address) pins. The LM80 can
only operate as a slave. The SCL line only controls the serial
interface, all other clock functions within LM80 such as the
ADC and fan counters are done with a separate asyn-
chronous internal clock.
When using the Serial Bus Interface a write will always consist
of the LM80 Serial Bus Interface Address byte, followed by
the Internal Address Register byte, then the data byte. There
are two cases for a read:
1.
If the Internal Address Register is known to be at the
desired Address, simply read the LM80 with the Serial
Bus Interface Address byte, followed by the data byte
read from the LM80.
(c) Serial Bus Read from a Register with the Internal Address Register Preset to Desired Location
FIGURE 5. Serial Bus Timing
11
2.
The default power on Serial Bus address for the LM80 is: 0101
(A2)(A1)(A0) binary, where A0-A2 reflect the state of the pins
defined by the same names.
All of these communications are depicted in the Serial Bus
Interface Timing Diagrams as shown in
If the Internal Address Register value is unknown, write
to the LM80 with the Serial Bus Interface Address byte,
followed by the Internal Address Register byte. Then
restart the Serial Communication with a Read consisting
of the Serial Bus Interface Address byte, followed by the
data byte read from the LM80.
Figure
5.
www.national.com
10004010