8300102QA E2V, 8300102QA Datasheet - Page 4

• Manufacturer Part Number: 8300102QA
• Manufacturer: E2V

Specifications of 8300102QA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in
the solicitation or contract.
the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
JAN class level B devices and as specified herein. Product built to this drawing that is produced by a Qualified Manufacturer
Listing (QML) certified and qualified manufacturer or a manufacturer who has been granted transitional certification to MIL-
PRF-38535 may be processed as QML product in accordance with the manufacturers approved program plan and qualifying
activity approval in accordance with MIL-PRF-38535. This QML flow as documented in the Quality Management (QM) plan
may make modifications to the requirements herein. These modifications shall not affect form, fit, or function of the device.
These modifications shall not affect the PIN as described herein. A "Q" or "QML" certification mark in accordance with MIL-
PRF-38535 is required to identify when the QML flow option is used.
in MIL-PRF-38535, appendix A and herein.
as specified in table I and shall apply over the full case operating temperature range.
tests for each subgroup are described in table I.
APR 97
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a
3.1 Item requirements. The individual item requirements shall be in accordance with MIL-PRF-38535, appendix A for non-
3.2 Design, construction, and physical dimensions. The design, construction, and physical dimensions shall be as specified
3.2.1 Case outlines. The case outlines shall be in accordance with 1.2.2 herein.
3.2.2 Terminal connections. The terminal connections shall be as specified on figure 1.
3.2.3 Logic functions. The logic functions shall be as specified on figure 2.
3.2.4 Timing waveforms. The timing waveforms shall be as specified on figure 3.
(Copies of these documents are available online at
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
3. REQUIREMENTS
3.3 Electrical performance characteristics. Unless otherwise specified herein, the electrical performance characteristics are
3.4 Electrical test requirements. The electrical test requirements shall be the subgroups specified in table II. The electrical
DEPARTMENT OF DEFENSE SPECIFICATION
DEPARTMENT OF DEFENSE STANDARDS
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-PRF-38535
MIL-STD-883
MIL-STD-1835
MIL-HDBK-103
MIL-HDBK-780
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
-
-
-
-
-
Integrated Circuits, Manufacturing, General Specification for.
Test Method Standard Microcircuits.
Interface Standard Electronic Component Case Outlines.
List of Standard Microcircuit Drawings.
Standard Microcircuit Drawings.
http://assist.daps.dla.mil/quicksearch/
SIZE
A
REVISION LEVEL
or
http://assist.daps.dla.mil
D
SHEET
83001
4
or from