AD7911ARMZ Analog Devices Inc, AD7911ARMZ Datasheet - Page 12

• Manufacturer Part Number: AD7911ARMZ
• Description: IC ADC 10BIT DUAL 2CH 8-MSOP
• Manufacturer: Analog Devices Inc

Specifications of AD7911ARMZ

• Data Interface: DSP, MICROWIRE™, QSPI™, Serial, SPI™
• Operating Temperature: -40°C ~ 85°C
• Number Of Bits: 10
• Sampling Rate (per Second): 250k
• Number Of Converters: 1
• Power Dissipation (max): 20mW
• Voltage Supply Source: Single Supply
• Mounting Type: Surface Mount
• Package / Case: 8-TSSOP, 8-MSOP (0.118", 3.00mm Width)
• Resolution (bits): 10bit
• Input Channel Type: Single Ended
• Supply Voltage Range - Analogue: 2.35V To 5.25V
• Supply Current: 4mA
• No. Of Pins: 8
• Sampling Rate: 250kSPS
• Rohs Compliant: Yes
• Number Of Elements: 1
• Resolution: 10Bit
• Architecture: SAR
• Sample Rate: 250KSPS
• Input Polarity: Unipolar
• Input Type: Voltage
• Rated Input Volt: 5.25V
• Differential Input: No
• Power Supply Requirement: Single
• Single Supply Voltage (typ): 3/5V
• Single Supply Voltage (min): 2.35V
• Single Supply Voltage (max): 5.25V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Power Dissipation: 20mW
• Differential Linearity Error: ±0.5LSB
• Integral Nonlinearity Error: ±0.5LSB
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 8
• Package Type: MSOP
• Input Signal Type: Single-Ended
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD7911/AD7921
Intermodulation Distortion
With inputs consisting of sine waves at two frequencies, fa and
fb, any active device with nonlinearities creates distortion
products at sum and difference frequencies of mfa ± nfb, where
m, n = 0, 1, 2, 3, and so on. Intermodulation distortion terms are
those for which neither m nor n is equal to zero. For example,
the second-order terms include (fa + fb) and (fa − fb), while the
third-order terms include (2fa + fb), (2fa − fb), (fa + 2fb), and
(fa − 2fb).
Rev. 0 | Page 12 of 28
The AD7911/AD7921 are tested using the CCIF standard,
where two input frequencies are used (see fa and fb in the
Specifications section). In this case, the second-order terms are
usually distanced in frequency from the original sine waves,
while the third-order terms are usually at a frequency close to
the input frequencies. As a result, the second-order and third-
order terms are specified separately. The calculation of the
intermodulation distortion is as in the THD specification,
where it is defined as the ratio of the rms sum of the individual
distortion products to the rms amplitude of the sum of the
fundamentals expressed in dB.