AD9288BSTZ-40 Analog Devices Inc, AD9288BSTZ-40 Datasheet - Page 16

• Manufacturer Part Number: AD9288BSTZ-40
• Description: IC ADC 8BIT DUAL 40MSPS 48-LQFP
• Manufacturer: Analog Devices Inc

Specifications of AD9288BSTZ-40

• Data Interface: Parallel
• Number Of Bits: 8
• Sampling Rate (per Second): 40M
• Number Of Converters: 2
• Power Dissipation (max): 189mW
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Resolution (bits): 8bit
• Sampling Rate: 40MSPS
• Input Channel Type: Differential
• Supply Voltage Range - Analog: 2.7V To 3.6V
• Supply Voltage Range - Digital: 2.7V To 3.6V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD9288
EVALUATION BOARD
The AD9218/AD9288 customer evaluation board offers an easy
way to test the AD9218 or the AD9288. The compatible pinout
of the two parts facilitates the use of one PCB for testing either
part. The PCB requires power supplies, a clock source, and a
filtered analog source for most ADC testing required.
POWER CONNECTOR
Power is supplied to the board via a detachable 12-lead power
strip. The minimum 3 V supplies required to run the board are
V
path, ±5 V supplies are required.
ANALOG INPUTS
Each channel has an independent analog path that uses a
wideband transformer to drive the ADC differentially from a
single-ended sine source at the input SMAs. The transformer
paths can be bypassed to allow the use of a dc-coupled path by
using two AD8138 op amps with a simple board modification.
The analog input should be band-pass filtered to remove any
harmonics in the input signal and to minimize aliasing.
VOLTAGE REFERENCE
The AD9288 has an internal 1.25 V voltage reference; an
external reference for each channel can be used instead by
connecting two external voltage references at the power
connector and setting jumpers at E18 and E19. The evaluation
board is shipped configured for internal reference mode.
DD
, V
DL
, and V
DD
. To allow the use of the optional amplifier
Rev. C | Page 16 of 24
CLOCKING
Each channel can be clocked by a common clock input at SMA
input ENCODE A/B. The channels can also be clocked
independently by a simple board modification. The clock input
should be a low jitter sine source for maximum performance.
DATA OUTPUTS
The data outputs are latched on-board by two 10-bit latches and
drive an 8-pin connector which is compatible with the dual-
channel FIFO board available from Analog Devices. This board,
together with ADC analyzer software, can greatly simplify ADC
testing.
DATA FORMAT/GAIN
The DFS/Gain pin can be biased for desired operation at the DFS
jumper located at the S1, S2 jumpers.
TIMING
Timing on each channel can be controlled if needed on the
PCB. Clock signals at the latches or the data ready signals that
go to the output 80-pin connector can be inverted if required.
Jumpers also allow for biasing of Pins S1 and S2 for power-
down and timing alignment control.