8-530843-3 TE Connectivity, 8-530843-3 Datasheet - Page 5

• Manufacturer Part Number: 8-530843-3
• Description: CONN SEC II 12 POS 100C/L
• Manufacturer: TE Connectivity

Specifications of 8-530843-3

• Product Type: Connector
• Product Series: Standard Edge II
• Type Of Connector: Standard
• Number Of Dual Positions: 12
• Post Type: Solder Post
• Pcb Mounting Orientation: Vertical
• Mounting Ears: Without
• Pcb Mount Retention: With
• Pcb Retention Location: 3-6, 19-22
• High Current: No
• Termination Post Length (mm [in]): 3.18 [0.125]
• Solder Tail Contact Plating: Tin
• Centerline (mm [in]): 2.54 [0.100]
• Retention Latch: Without
• Positions Unloaded: None
• Contact Plating, Mating Area, Material: Gold (30)
• Contact Base Material: Phosphor Bronze
• Underplate Material: Nickel
• Housing Material: Polyester GF
• Housing Color: Black
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: ELV compliant, 5 of 6 Compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C

4.
4.1.
4.2.
4.3.
4.4.
Rev K
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. W hen
product failure occurs, corrective action shall be taken and sam ples resubm itted for qualification.
Testing to confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan will specify the sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Sam ple Selection
Connector housings and contacts shall be prepared in accordance with applicable Instruction
Sheets and shall be selected at random from current production. All test groups shall consist of 10
connectors of greatest num ber of positions available. 5 connectors from each of 2 different plating
configurations. Test groups 1, 2 and 3 shall be soldered to printed circuit boards. W here individual
contact m easurem ents are required, a m inim um of 30 random ly selected contacts distributed
am ong the 5 connectors shall be m easured.
Test Sequence
Qualification inspection shall be verified by testing sam ples as specified in Figure 2.
108-9039
5 of 7