SP000105547ZV Infineon Technologies, SP000105547ZV Datasheet - Page 7

• Manufacturer Part Number: SP000105547ZV
• Manufacturer: Infineon Technologies

Specifications of SP000105547ZV

• Switch Type: Low Side
• Power Switch Family: TLE 7230
• Input Voltage: -0.3 to 6V
• Power Switch On Resistance: 800mOhm
• Output Current: 1A
• Number Of Outputs: 8
• Mounting: Surface Mount
• Supply Current: 3mA
• Package Type: DSO
• Operating Temperature (min): -40C
• Operating Temperature (max): 150C
• Operating Temperature Classification: Automotive
• Pin Count: 38
• Lead Free Status / Rohs Status: Compliant

Note: The overtemperature sensors of the output channels are only active if the channel is turned on.
Low Quiescent Current Mode (Sleep Mode) :
By applying a low signal at the Reset Pin, the device can be set to sleep mode. In this mode, all out-
puts are turned off, diagnosis and biasing are disabled, the diagnosis and the on/off register are reset
and the current consumption is drastically reduced (<10µA). Once the reset signal returns to high, all
outputs except for those controlled by parallel inputs remain off.
Overload Protection:
The IC can be programmed to react in different ways to overload.
Pin description:
OUTPUT 1 to 8 – Drain pins of the 8 channels. Output pins to connect to loads.
GND – Ground pins.
IN 1 to 3 – Parallel Input Pins of the channels 1 to 3
IN 4 – Mapable parallel Input Pin. Can be assigned to different outputs by SPI command. Default Out-
put is OUT4
PRG - Program pin.
If the parallel input pins are not connected (independent of high or low activity) it is guaran-
teed that the channels 1 to 4 are switched OFF.
PRG pin itself is internally pulled up when not connected.
Reset - If the reset pin is in a logic low state, it clears the SPI shift register and switches all
outputs OFF. An internal pull-up structure is provided on chip.
Fault - There is a general fault pin (open drain) which shows a high to low transition as soon
as an error occurs at any one of the eight channels. This fault indication can be used to gen-
erate a µC interrupt. Therefore a ‘diagnosis’ interrupt routine need only be called after this
fault indication. This saves processor time compared to a cyclic reading of the SO information.
VDO – Supply pin of the Signal Output (SO) pin of the SPI interface . This pin can be used to vary the
high-state output voltage of the SO pin.
Vs – Logic supply pin. This pin is used to supply the integrated circuitry.
V3.4
Only Current limit: The IC actively limits the current to the specified current limit value. If the
current limitation is active for longer than the fault filtering time, a fault is reported and stored in
the Fault register. Unless the channel reaches the overtemperature shutdown threshold, the
channel is not shutdown.
Current limit + shutdown: The IC actively limits the current to the specified current limit value.
If this current limit is active for more than the specified Overload switch off delay time the af-
fected channel is turned off and the fault is reported and stored in the fault register. To turn on
the channel again this overload latch must be reset with a Là H transition of the input signal
(parallel /SPI depending on the programmed operation).
PRG = High (V
PRG = Low (GND): Parallel inputs 1 to 4 are low active.
S
):
Page
Parallel inputs 1 to 4 are high active
7
D a t a S h e e t T L E 7 2 3 0 R
2009-07-15