N010-0510-T217 Fujitsu Components, N010-0510-T217 Datasheet - Page 6

• Manufacturer Part Number: N010-0510-T217
• Manufacturer: Fujitsu Components

Specifications of N010-0510-T217

• Operating Temperature Classification: Commercial
• Lead Free Status / Rohs Status: Compliant

1.
2.
3.
4.
5.
6.
7.
n 9.0 CONNECTION AND MOUNTING
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure sup-
port to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area). Also
ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed ac-
tive area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel and
enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch panel
are conductive so do not touch any metal parts after mounting.
(Mating connector type FCI or equivalent SFW15R-1ST: for FPC)
1.0 to 3.0 mm
Location
Right/ Upper
Right/ Upper
Each side
Left/ Lower
Each side
Left/ Lower
All
Film
Shock absorber to protect
the panel (eg rubber)
Detect
Glass
Glass
Glass
Glass
Glass
Glass
View Area
Bottom View (Drawing, with conductive side up)
Transparent Area
Input Area
Input Panel
Anti-input Area
Conductive Face
0.7
Circuit Board
LCD
FPC-type cable
3.35
0.8 mm min.
Upper Case
Wiring Area
Connector
FID-550 SERIES
Shock absorber
for protection
Top View (Picture, with conductive
side down)
Contact Section View
Cut-out / avoidance of
550 surface mount diodes
Laminate Film
Stiffener Board
6