101-0492 Rabbit Semiconductor, 101-0492 Datasheet - Page 13

• Manufacturer Part Number: 101-0492
• Description: INTERFACE OP6800 W/ETHERNET PORT
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0492

• Module/board Type: Single Board Computer Module
• For Use With/related Products: SR9160
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 316-1060

3. Connect the power supply.
First, prepare the AC adapter for the country where it will be used by selecting the plug.
The OP6800 Tool Kit presently includes Canada/Japan/U.S., Australia/N.Z., U.K., and
European style plugs. Snap in the top of the plug assembly into the slot at the top of the
AC adapter as shown in Figure 4, then press down on the spring-loaded clip below the
plug assembly to allow the plug assembly to click into place.
Connect the bare ends of the power supply to the
minal header J5 of the Demonstration Board as shown in Figure 4.
4. Apply power.
Plug in the AC adapter.
User’s Manual
CAUTION: Unplug the power supply while you make or otherwise work with the connections
NOTE: A hardware RESET is done by unplugging the AC adapter, then plugging it back in.
to the headers. This will protect your OP6800 from inadvertent shorts or power spikes.
NOTE: The OP6800 itself has reverse polarity protection, but the Demonstration Board
NOTE: If you are using your own power supply, Rabbit recommends using a 9 V to 25 V
does not. Be careful to connect the positive and negative leads as shown to avoid damag-
ing the Demonstration Board.
DC power supply. The linear regulator on the Demonstration Board can handle up to
35 V, but can get extremely hot.
Figure 4. Power Supply Connections
+RAW
and
GND
positions on screw ter-
9