MPC8347VVAJFB Freescale Semiconductor, MPC8347VVAJFB Datasheet - Page 75

• Manufacturer Part Number: MPC8347VVAJFB
• Description: IC MPU POWERQUICC II 672-TBGA
• Manufacturer: Freescale Semiconductor
• Series: PowerQUICC IIr

Specifications of MPC8347VVAJFB

• Processor Type: MPC83xx PowerQUICC II Pro 32-Bit
• Speed: 533MHz
• Voltage: 1.2V
• Mounting Type: Surface Mount
• Package / Case: 672-TBGA
• Processor Series: MPC8xxx
• Core: e300
• Data Bus Width: 32 bit
• Development Tools By Supplier: MPC8349E-MITXE
• Maximum Clock Frequency: 533 MHz
• Maximum Operating Temperature: + 105 C
• Mounting Style: SMD/SMT
• I/o Voltage: 1.8 V, 2.5 V, 3.3 V
• Minimum Operating Temperature: 0 C
• Family Name: MPC83xx
• Device Core: PowerQUICC II Pro
• Device Core Size: 32b
• Frequency (max): 533MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 1.2V
• Operating Supply Voltage (max): 1.26V
• Operating Supply Voltage (min): 1.14V
• Operating Temp Range: 0C to 105C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 672
• Package Type: TBGA
• Core Size: 32 Bit
• Program Memory Size: 64KB
• Cpu Speed: 533MHz
• Embedded Interface Type: I2C, SPI, UART
• Digital Ic Case Style: TBGA
• No. Of Pins: 672
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Freescale Semiconductor
MVREF1
MVREF2
NC
Notes:
1. This pin is an open-drain signal. A weak pull-up resistor (1 kΩ) should be placed on this pin to OV
2. This pin is an open-drain signal. A weak pull-up resistor (2–10 kΩ) should be placed on this pin to OV
3. During reset, this output is actively driven rather than three-stated.
4. These JTAG pins have weak internal pull-up P-FETs that are always enabled.
5. This pin should have a weak pull-up if the chip is in PCI host mode. Follow the PCI specifications.
6. This pin must always be tied to GND.
7. This pin must always be left not connected.
8. Thermal sensitive resistor.
9. It is recommended that MDIC0 be tied to GRD using an 18 Ω resistor and MDIC1 be tied to DDR power using an 18 Ω resistor.
10.TSEC1_TXD[3] is required an external pull-up resistor. For proper functionality of the device, this pin must be pulled up or
actively driven high during a hard reset. No external pull-down resistors are allowed to be attached to this net.
MPC8347E PowerQUICC™ II Pro Integrated Host Processor Hardware Specifications, Rev. 11
Signal
Table 52. MPC8347E (PBGA) Pinout Listing (continued)
AF19
AE10
V1, V2, V5
No Connection
Package Pin Number
Pin Type
I
I
DD
.
DD
reference
reference
Supply
voltage
voltage
Power
.
DDR
DDR
Notes
75