SDV-FL3 DC48 Omron, SDV-FL3 DC48 Datasheet - Page 56

• Manufacturer Part Number: SDV-FL3 DC48
• Description: Sensor Hardware & Accessories VOLTAGE SENSOR
• Manufacturer: Omron

Specifications of SDV-FL3 DC48

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Precautions
• Use a commercial frequency power supply as the AC control power
• This Current Sensor cannot be used for circuits that may exhibit
• Use the K2CM for circuits incorporating inverters.
• This Current Sensor cannot be used for inching operation. The
• Do not use the SET-3 Current Converter with positive and negative
• After the LED indicator turns ON, it will turn OFF when the control
Mounting
• When installing with an 8PFA1 connecting socket, first fasten the
• There is no particular restriction regarding the mounting direction.
• When panel mounting the Sensor, obtain the mounting brackets for
Connections
• Determine the necessary number of conductor passes from the
• Be sure to connect the Current Sensor and Current Converter with
• It is not necessary to consider polarity when using a DC control
54
Cat. No. N123-E1-01
supply.
current waveform distortion, such as in thyristor control, circuits
that incorporate inverters or rectifiers, high-frequency circuits, and
capacitor loads.
internal overcurrent detecting circuit is reset with each inching
operation.
output terminals open. Short-circuit these terminals if they are not
used.
power supply voltage is turned OFF.
socket firmly to the panel with screws, then insert the Sensor and
secure it with the hook. Leave a gap of around 30 mm between
Sensors to allow for the hooks.
Mount the Sensor as horizontally and securely as possible.
panel mounting SE Relays. The recommended panel thickness for
panel mounting is 1 to 3.2 mm.
Current Settings table and pass the all three wires through the
holes in the same direction. It does not matter which wire does
through which hole.
the correct polarity. Not doing so may result in malfunction.
power supply.
Correct Use
One conductor pass
(The conductors pass
through the holes once.)
Current Sensor (Single-phase)
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Four conductor passes
(The conductors pass
through the holes four times.)
In the interest of product improvement, specifications are subject to change without notice.
SAO-@S