EMC1412-1-ACZL-TR SMSC, EMC1412-1-ACZL-TR Datasheet - Page 18

• Manufacturer Part Number: EMC1412-1-ACZL-TR
• Description: Board Mount Temperature Sensors SMBus Temp Sensor Selectable Address
• Manufacturer: SMSC

Specifications of EMC1412-1-ACZL-TR

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Chapter 6 Product Description
Revision 1.38 (10-25-10)
6.1
6.1.1
CPU / GPU
Thermal
Junction
The EMC1412 is an SMBus temperature sensor. The EMC1412 monitors one internal diode and one
externally connected temperature diode.
Thermal management is performed in cooperation with a host device. This consists of the host reading
the temperature data of both the external and internal temperature diodes of the EMC1412 and using
that data to control the speed of one or more fans.
The EMC1412 has two levels of monitoring. The first provides a maskable ALERT signal to the host
when the measured temperatures exceeds user programmable limits. This allows the EMC1412 to be
used as an independent thermal watchdog to warn the host of temperature hot spots without direct
control by the host. The second level of monitoring provides a non maskable interrupt on the THERM
pin if the measured temperatures meet or exceed a second programmable limit.
The EMC1412 has two modes of operation.
Conversion Rates
The EMC1412 may be configured for different conversion rates based on the system requirements.
The conversion rate is configured as described in
conversions per second. Other available conversion rates are shown in
Modes of Operation
Figure 6.1
Active (Run) - In this mode of operation, the ADC is converting on all temperature channels at the
programmed conversion rate. The temperature data is updated at the end of every conversion and
the limits are checked. In Active mode, writing to the one-shot register will do nothing.
Standby (Stop) - In this mode of operation, the majority of circuitry is powered down to reduce
supply current. The temperature data is not updated and the limits are not checked. In this mode
of operation, the SMBus is fully active and the part will return requested data. Writing to the one-
shot register will enable the device to update all temperature channels. Once all the channels are
updated, the device will return to the Standby mode.
shows a system level block diagram of the EMC1412.
DN
DP
EMC1412
Figure 6.1 System Diagram for EMC1412
GND
VDD
DATASHEET
VDD = 3.3V
SMCLK
SMDATA
ALERT
THERM / ADDR
Multiple Channel 1°C Temperature Sensor with Beta Compensation
18
3.3V – 5V
Section
7.5. The default conversion rate is 4
Interface
SMBus
Power Control
Host
Table 7.6, "Conversion
SMSC EMC1412
Datasheet
Rate".