SA56004AD NXP Semiconductors, SA56004AD Datasheet - Page 33

• Manufacturer Part Number: SA56004AD
• Description: Board Mount Temperature Sensors I2C LOC +/- 2OC AND REM +/- 1OC TS
• Manufacturer: NXP Semiconductors

Specifications of SA56004AD

• Full Temp Accuracy: +/- 1 C, +/- 3 C
• Package / Case: SOT-96
• Digital Output - Bus Interface: I2C
• Digital Output - Number Of Bits: 11 bit
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Output Type: Digital
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: SA56004AD,112

NXP Semiconductors
16. Abbreviations
SA56004X_5
Product data sheet
Table 22.
Acronym
A/D
ARA
ASIC
CRT
ESD
HBM
HVAC
I
LSB
MM
MSB
OTP
POR
PTAT
SMBus
UVL
2. Route the D+ and D lines parallel and close together with ground guards enclosing
3. Leakage currents due to printed-circuit board contamination must be considered.
4. Use wide traces to reduce inductance and noise pick-up. Narrow traces more readily
5. Place a bypass capacitor of 10 nF close to the V
6. A shielded twisted pair is recommended if remote sensor is located several feet away
2
Fig 25. D+ and D trace layout
C-bus
them (see
Error can be introduced by these leakage currents.
pick up noise. The minimum width of 10 mil and space of 10 mil are recommended.
2200 pF close to the D+ and D pins.
from the temperature sensor. Under this circumstance, connect the shield of the cable
at the device side to the SA56004X GND pin and leave the shield at the remote end
unconnected to avoid ground loop currents. Also notice that the series resistance of
the cable may introduce measurement error; 1
Abbreviations
Figure
Description
Analog-to-Digital
Alert Response Address
Application Specific Integrated Circuit
Cathode Ray Tube
ElectroStatic Discharge
Human Body Model
Heating, Ventilating and Air Conditioning
Inter-Integrated Circuit bus
Least Significant Bit
Machine Model
Most Significant Bit
One-Time Programmable
Power-On Reset
Proportional To Absolute Temperature
System Management Bus
Under Voltage Lockout
25).
Rev. 05 — 22 May 2008
GND
GND
D+
D
Digital temperature sensor with overtemperature alarms
DD
can introduce about 0.5 C.
pin and an input filter capacitor of
002aad227
SA56004X
© NXP B.V. 2008. All rights reserved.
33 of 36