VXZ2230H-03N-5DZ1-B SMC Corporation, VXZ2230H-03N-5DZ1-B Datasheet - Page 5

• Manufacturer Part Number: VXZ2230H-03N-5DZ1-B
• Description: Process Solenoid Valve, ss, pilot operated, zero dif, 3/8 port, NC, 24VDC, DIN
• Manufacturer: SMC Corporation
• Type: Pilot Operatedr

Specifications of VXZ2230H-03N-5DZ1-B

• Brand/series: VX Series
• Primary Type: Solenoid Valve
• Size, Port: 3⁄8" NPTF
• Voltage, Coil: 24 VDC
• Enclosure: Equivalent to IP65
• Lead Free Status / Rohs Status: RoHS Exempt Product

2. Min. operating pressure differential
3. Max. system presure
4. Proof pressure
1. Apparent power (VA)
2. Surge voltage
3. Hum sound
1. Max. operating pressure differential
Pressure
Electricity
Refer to page 17-6-3 for Safety Instructions and Solenoid
Valve Precautions.
This pressure difference is the highest pressure
difference allowable to operate (a difference be-
tween the pressures in the inlet slide and the out-
let side) in an open state and the closed state of
valve. A case of 0 kgf/cm
sults in the highest operating pressure.
This pressure difference is the lowest pressure
difference (a difference between the pressures in
the inlet slide and the outlet side) required to
hold the main valve fully open.
This pressure is the limit of pressure that can be
applied to pipe line. (Line pressure)
[The pressure difference in a solenoid valve must
be maintained less than the highest operating
pressure difference.]
This is the pressure that can be withstood with-
out deterioration of the performance when valve
returns within the range of the operating pres-
sure. (A value under a specified condition.)
Volt-ampere is the product of voltage (V) and cur-
rent (A). Power dissipation (W): For AC , W = V/A
cosθ. For DC, W = V/A (Note) cosθ shows power
factor.
The surge voltage is a high voltage generated mo-
mentarily when cutting the power supply.
The hum sound is a noise generated through re-
peated adsorption and releasing on an armature
adsorption surface.
For an AC solenoid, no shading coil releases the
spring reaction because of the existance of a 0
point (twice per frequency) of the suction force.
Caution
2
in the outlet side re-
Glossary
1. Material
2. Oil preserve treatment
3. Symbol
Others
NBR: Nitrile rubber
FKM: Fluoro rubber — Trade names: Vitron
EPDM: Ethylene propylene rubber
PTFE: Polytetrafluoroethylene resin—Trade names:
Polyacetal (POM)—Trade names: Duracon
Derlin
After assembly, valve is put through a parts washer
to remove any oil used during assembly.
The JIS symbol is (
to be normally closed.
However, in situations where the secondary pres-
sure exceeds the primary side pressure, the result-
ing back pressure will cause back flow through the
valve.
®
Dai-el
Teflon
, etc.
®
, etc.
®
, Polyflon
®
, etc.
): this designates the valve
®
®
,
,
Series
17-3-15
VX
VC„
VDW
VQ
VX2
VX„
VX3
VXA
VN„
LVC
LVA
LVH
LVD
LVQ
LQ
LVN
TI/
TIL
PA
PAX
PB