PCA9670D,518 NXP Semiconductors, PCA9670D,518 Datasheet - Page 13

• Manufacturer Part Number: PCA9670D,518
• Description: IC I/O EXPANDER I2C 8B 16SOIC
• Manufacturer: NXP Semiconductors

Specifications of PCA9670D,518

• Package / Case: 16-SOIC (0.300", 7.5mm Width)
• Interface: I²C
• Number Of I /o: 8
• Interrupt Output: No
• Frequency - Clock: 1MHz
• Voltage - Supply: 2.3 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Includes: POR
• Logic Family: PCA
• Operating Supply Voltage: 2.3 V to 5.5 V
• Power Dissipation: 400 mW
• Operating Temperature Range: - 40 C to + 85 C
• Maximum Clock Frequency: 1000 KHz
• Mounting Style: SMD/SMT
• Output Current: 50 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-4188-2; 935282715518; PCA9670D-T

NXP Semiconductors
9. Characteristics of the I
PCA9670_2
Product data sheet
9.1.1 START and STOP conditions
9.1 Bit transfer
The I
lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be
connected to a positive supply via a pull-up resistor when connected to the output stages
of a device. Data transfer may be initiated only when the bus is not busy.
One data bit is transferred during each clock pulse. The data on the SDA line must remain
stable during the HIGH period of the clock pulse as changes in the data line at this time
will be interpreted as control signals (see
Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW
transition of the data line while the clock is HIGH is defined as the START condition (S). A
LOW-to-HIGH transition of the data line while the clock is HIGH is defined as the STOP
condition (P) (see
Fig 14. Bit transfer
Fig 15. Definition of START and STOP conditions
2
C-bus is for 2-way, 2-line communication between different ICs or modules. The two
SDA
SCL
START condition
2
SDA
SCL
Figure
C-bus
S
Rev. 02 — 17 July 2007
15.)
Remote 8-bit I/O expander for Fm+ I
data valid
data line
stable;
Figure
allowed
change
of data
14).
STOP condition
mba607
P
PCA9670
© NXP B.V. 2007. All rights reserved.
2
C-bus with reset
mba608
SDA
SCL
13 of 28