CC-56K2-CP5 Copeland Communications Inc, CC-56K2-CP5 Datasheet - Page 29

• Manufacturer Part Number: CC-56K2-CP5
• Description: MODEM 56KBAUD PARALLEL 5V
• Manufacturer: Copeland Communications Inc

Specifications of CC-56K2-CP5

• Data Format: V.22, V23, V.32, V.34, V.90, Bell 103, Bell 212A
• Baud Rates: 56k
• Interface: UART
• Voltage - Supply: 4.2 V ~ 7 V
• Mounting Type: Surface Mount
• Package / Case: Module
• For Use With: 539-1002 - KIT EVALUATION WORLD MODEM II
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Extended AT\ Command Set
© 2004, Copeland Communications, Inc.
Command
\Bn
\B0
\B1
\B2
\B3
\B5
\B6
\Nn
\N0
\N2
\N3
\N4
\N5
\Pn
\P0
\P1
\P2
\P3
\Qn
\Q0
\Q2
\Q3
\Q4
\$
Display AT\ command settings.
Character length will be automatically set in autobaud mode.
6N1 - six data bits, no parity, one stop bit, one start bit, eight bits total (\N0 only)
7N1 - seven data bits, no parity, one stop bit, one start bit, nine bits total (\N0 only)
7P1 - seven data bits, parity options by \P, one stop bit, one start bit, 10 bits total.
8N1 - eight data bits, no parity, one stop bit, one start bit, 10 bits total.
8P1 - eight data bits, parity optioned by \P, one stop bit, one start bit, 11 bits total (\N0 only).
8X1 - eight data bits, one escape bit, one stop bit, one start bit, 11 bits total (enables ninth-bit
escape mode).
Asynchronous protocol.
Wire mode (no error correction, no compression).
MNP reliable mode. The modem attempts to connect with the MNP protocol. If unsuccessful, the
call is dropped.
V.42 auto-reliable - The modem attempts to connect with the V.42 protocol. If unsuccessful,
the MNP protocol is attempted. If unsuccessful, wire mode is attempted.
V.42 (LAPM) reliable mode (or drop call) - Same as \N3 except that the modem drops the call
instead of connecting in MNP or wire mode.
V.42 and MNP reliable mode - The modem attempts to connect with V.42. If un successful, MNP
is attempted. If MNP is unsuccessful, the call is dropped.
Parity type will be automatically set in autobaud mode.
Even
Space
Odd
Mark
Modem-to-DTE flow control.
Disable all flow control - This may only be used if the DTE speed and the VF speed are
guaranteed to match throughout the call.
Use CTS only.
Use RTS/CTS
Use XON/XOFF flow control for modem-to-DTE interface. Does not enable modem-to-modem
flow control.
1
1
(Command Defaults in Bold)
Page 29 of 60
Data Sheet
Action
World modem II Datasheet Rev 1.1
World modem II
1
1