AT42QT1010-TSHR Atmel, AT42QT1010-TSHR Datasheet - Page 9

• Manufacturer Part Number: AT42QT1010-TSHR
• Description: IC TOUCH SENSOR 1KEY SOT23-6
• Manufacturer: Atmel
• Series: QTouch™r
• Type: Capacitiver

Specifications of AT42QT1010-TSHR

• Touch Panel Interface: 1, 2-Wire
• Number Of Inputs/keys: 1 Key
• Resolution (bits): 9, 14 b
• Data Interface: Serial
• Voltage Reference: Internal
• Voltage - Supply: 1.8 V ~ 5.5 V
• Current - Supply: 219µA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-6
• Output Type: Logic
• Interface: Digital
• Input Type: Logic
• Supply Current: 729µA
• Supply Voltage Range: 1.8V To 5.5V
• Sensor Case Style: SOT-23
• No. Of Pins: 6
• Operating Temperature Range: -40°C To +85°C
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AT42QT1010-TSHRTR

3.9.3
9541G–AT42–03/10
Output Drive
The HeartBeat indicator can be sampled by using a pull-up resistor on the OUT pin
and feeding the resulting positive-going pulse into a counter, flip flop, one-shot, or other circuit.
The pulses will only be visible when the chip is not detecting a touch.
Figure 3-6.
If the sensor is wired to a microcontroller as shown in
can reconfigure the load resistor to either Vss or Vdd depending on the output state of the
QT1010, so that the pulses are evident in either state.
Figure 3-7.
Electromechanical devices like relays will usually ignore the short HeartBeat pulse. The pulse
also has too low a duty cycle to visibly affect LEDs. It can be filtered completely if desired, by
adding an RC filter to the output, or if interfacing directly and only to a high-impedance CMOS
input, by doing nothing or at most adding a small noncritical capacitor from OUT to Vss.
The OUT pin is active high and can sink or source up to 2 mA. When a large value of Cs
(>20 nF) is used the OUT current should be limited to <1 mA to prevent gain-shifting side
effects, which happen when the load current creates voltage drops on the die and bonding
wires; these small shifts can materially influence the signal level to cause detection instability.
Obtaining HeartBeat Pulses with a Pull-up Resistor
Using a Microcontroller to Obtain HeartBeat Pulses in Either Output State
Microcontroller
HeartBeat™ Pulses
PORT_M.x
PORT_M.y
Ro
R
o
1
OUT
VDD
5
2
Figure 3-7 on page
VDD
VSS
SYNC
1
SNSK
SNS
OUT
3
4
6
SYNC
SNSK
AT42QT1010
SNS
9, the microcontroller
3
4
6
(Figure
3-6),
9