A-12W-K Fujitsu Components, A-12W-K Datasheet - Page 7

• Manufacturer Part Number: A-12W-K
• Manufacturer: Fujitsu Components
• Type: Miniature Relayr

Specifications of A-12W-K

• Relay Construction: Non-Latching
• Contact Arrangement: DPDT
• Coil Voltage Dc: 12V
• Coil Current: 11.67mA
• Contact Form: 2 Form C
• Voltage Rating (vdc): 110V
• Voltage Rating (vac): 125V
• Dropout Volt (min): 1.2VDCV
• Coil Resistance: 1.028kohm
• Pick-up Voltage (max): 9VDC
• Maximum Power Rating: 30W/62.5VA
• Operate Time: 6ms
• Contact Current Rating: 2A
• Contact Material: Ag/Au
• Coil Suppression Diode: No
• Push To Test Button: No
• Led Indicator: No
• Seal: Sealed
• Product Height (mm): 5mm
• Product Depth (mm): 9mm
• Product Length (mm): 14mm
• Operating Temp Range: -40C to 85C
• Pin Count: 10
• Mounting Style: Through Hole
• Termination Style: Solder Pin
• Package / Case: DIP
• Lead Free Status / Rohs Status: Compliant

RoHS Compliance and Lead Free Relay Information
1. General Information
l
l
l
l
l
l
l
Note: Cadmium was exempted from RoHS on October 21, 2005. (Amendment to Directive 2002/95/EC)
2. Recommended Lead Free Solder Profile
l
Reflow Solder condition
3. Moisture Sensitivity
l
4. Tin Whisker
l
Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu.
All signal and most power relays also comply with RoHS. Please refer to individual data
It has been verified that using lead-free relays in leaded assembly process will not cause any
“LF” is marked on each outer and inner carton. (No marking on individual relays).
Flow Solder condition:
Pre-heating:
Soldering:
Solder by Soldering Iron:
Soldering Iron
Temperature:
Duration:
(http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf)
sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that
are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE).
To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office.
We will ship leaded relays as long as the leaded relay inventory exists.
Moisture Sensitivity Level standard is not applicable to electromechanical realys.
Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in
house test.
Relays produced after the specific date code that is indicated on each data sheet are lead-free
now. Most of our signal and power relays are lead-free. Please refer to Lead-Free Status Info.
problems (compatible).
Recommended solder paste Sn-3.0Ag-0.5Cu.
We highly recommend that you confirm your actual solder conditions
maximum 120˚C
dip within 5 sec. at
260˚C soler bath
maximum 360˚C
maximum 3 sec.
A SERIES
7