ADG701BRM Analog Devices Inc, ADG701BRM Datasheet - Page 8

• Manufacturer Part Number: ADG701BRM
• Description: IC SWITCH SPST 8MSOP
• Manufacturer: Analog Devices Inc

Specifications of ADG701BRM

• Rohs Status: RoHS non-compliant
• Function: Switch
• Circuit: 1 x SPST- NC
• On-state Resistance: 3 Ohm
• Voltage Supply Source: Single Supply
• Voltage - Supply, Single/dual (±): 1.8 V ~ 5.5 V
• Current - Supply: 0.001µA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-TSSOP, 8-MSOP (0.118", 3.00mm Width)

ADG701/ADG702
TERMINOLOGY
Table 7.
Term
R
R
I
I
I
V
C
C
C
t
t
Off Isolation
Charge Injection
Bandwidth
On Response
On Loss
S
D
D
ON
OFF
ON
FLAT(ON)
D
S
D
D
, I
(OFF)
(OFF)
, C
(OFF)
(VS)
(OFF)
S
(ON)
S
(ON)
Description
Ohmic resistance between D and S.
Flatness is defined as the difference between the maximum and minimum value of on resistance as measured over the
specified analog signal range.
Source leakage current with the switch off.
Drain leakage current with the switch off.
Channel leakage current with the switch on.
Analog voltage on terminals D and S.
Off switch source capacitance.
Off switch drain capacitance.
On switch capacitance.
Delay between applying the digital control input and the output switching on. See Figure 14.
Delay between applying the digital control input and the output switching off.
A measure of unwanted signal coupling through an off switch.
A measure of the glitch impulse transferred from the digital input to the analog output during switching.
The frequency at which the output is attenuated by −3 dB.
The frequency response of the on switch.
The voltage drop across the on switch seen in Figure 10 as the number of decibels that the signal is from 0 dB at very
low frequencies.
Rev. C | Page 8 of 12