1-145169-2 TE Connectivity, 1-145169-2 Datasheet - Page 5

• Manufacturer Part Number: 1-145169-2
• Description: DIN 41612 Connectors AMP .050C/L PCI 92 D 210
• Manufacturer: TE Connectivity

Specifications of 1-145169-2

• Number Of Rows: 2
• Number Of Positions / Contacts: 18
• Contact Plating: Gold
• Pcb Mounting Orientation: Vertical
• Number Of Dual Positions: 92
• Pcb Mount Style: Through Hole
• Holddown Material: Brass
• Holddown Plating: Tin-Lead over Nickel
• Voltage (vac): 5
• Termination Post Length (mm [in]): 3.56 [0.140]
• Solder Tail Contact Plating: Tin-Lead over Nickel
• Number Of Positions: 184
• Centerline (mm [in]): 1.27 [0.050]
• Bus Width: 64 Bit
• Pcb Mount Retention Type: Hold Down Post(s)
• Ejector: Without
• Number Of Holddowns: 3
• Family Name: PCI
• Contact Plating, Mating Area, Material: Gold (30)
• Contact Base Material: Phosphor Bronze
• Housing Color: White
• Housing Material: Thermoplastic - GF
• Rohs/elv Compliance: Not ELV/RoHS compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Lead Free Status / Rohs Status: No

4.
4.1.
4.2.
4.3.
4.4.
Rev D
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product m eets requirem ents of Figure 1. Failures attributed to
equipm ent, test setup or operator deficiencies shall not disqualify product. W hen product failure occurs,
corrective action shall be taken and sam ples resubm itted for qualification. Testing to confirm corrective
action is required before resubm ittal.
Quality Conform ance Inspection
Applicable quality inspection plan will specify sam pling acceptable quality level to be used. Dim ensional
and functional requirem ents shall be in accordance with applicable product drawing and this
specification.
Sam ple Selection
Sam ples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall consist of 5 sam ples each.
Test Sequence
Qualification inspection shall be verified by testing sam ples as specified in Figure 2.
108-14034
5 of 6