AT32UC3B0512 Atmel Corporation, AT32UC3B0512 Datasheet - Page 103

• Manufacturer Part Number: AT32UC3B0512
• Manufacturer: Atmel Corporation

Specifications of AT32UC3B0512

• Flash (kbytes): 512 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 60 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 44
• Ext Interrupts: 44
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 4
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 16
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

9.2.14.6
32002F–03/2010
Debug Communication Control Register (DCCR)
Table 9-9.
To enable the DCCPU read and DCEMU dirty interrupts the corresponding enable bits must be
set in this register.
Table 9-10.
R/W
R/W
R/W
R/W
R/W
R
R/W
R/W
Bit Number
1
1
0
Bit Number
31:2
1
0
Debug Communication Status Register
Debug Communication Control Register
Field Name
CPURI
EMUD
CPUD
Field Name
Reserved
DCCPUIMASK
DCEMUIMASK
Init. Val.
0
0
0
Init. Val.
0x0000_
0000
0
0
Description
CPU Data Read Interrupt flag
0 = DCCPU has not been read since the clearing
of this bit.
1 = DCEMU has been read.
This bit is cleared by writing this bit to 0.
Emulator Data Dirty
0 = DCEMU has not been written to since last read
from CPU.
1 = DCEMU contains a new data value.
This bit is cleared by reading DCEMU.
CPU Data Dirty
0 = DCCPU has not been written to since last read
from emulator.
1 = DCCPU contains a new data value.
This bit is cleared by reading DCCPU.
Description
Reserved
These bits are reserved, and will always read
as 0
DCCPU Interrupt Mask
0 = DCCPU interrupts are disabled.
1 = DCCPU interrupts are enabled.
DCEMU Interrupt Mask
0 = DCEMU interrupts are disabled.
1 = DCEMU interrupts are enabled.
AVR32
103