TDA7466 STMicroelectronics, TDA7466 Datasheet - Page 7

• Manufacturer Part Number: TDA7466
• Description: IC PROCESSOR AUDIO DGTL 42-SDIP
• Manufacturer: STMicroelectronics
• Type: Audio Processorr

Specifications of TDA7466

• Applications: Automotive Systems
• Mounting Type: Through Hole
• Package / Case: 42-SDIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

I
Data transmission from microprocessor to the
TDA7466 and viceversa takes place through the
2 wires I
lines SDA and SCL (pull-up resistors to positive
supply voltage must be connected).
Data Validity
As shown in fig. 3, the data on the SDA line must
be stable during the high period of the clock. The
HIGH and LOW state of the data line can only
change when the clock signal on the SCL line is
LOW.
Start and Stop Conditions
As shown in fig.4 a start condition is a HIGH to
LOW transition of the SDA line while SCL is
HIGH. The stop condition is a LOW to HIGH tran-
sition of the SDA line while SCL is HIGH.
Byte Format
Every byte transferred on the SDA line must con-
tain 8 bits. Each byte must be followed by an ac-
Figure 3: Data Validity on the I
Figure 4: Timing Diagram of I
Figure 5: Acknowledge on the I
2
C BUS INTERFACE
2
C BUS interface, consisting of the two
2
CBUS
2
2
CBUS
CBUS
knowledge bit. The MSB is transferred first.
Acknowledge
The master ( P) puts a resistive HIGH level on the
SDA line during the acknowledge clock pulse (see
fig. 5). The peripheral (audioprocessor) that ac-
knowledges has to pull-down (LOW) the SDA line
during this clock pulse.
The audioprocessor which has been addressed
has to generate an acknowledge after the recep-
tion of each byte, otherwise the SDA line remains
at the HIGH level during the ninth clock pulse
time. In this case the master transmitter can gen-
erate the STOP information in order to abort the
transfer.
Transmission without Acknowledge
Avoiding to detect the acknowledge of the audio-
processor, the P can use a simpler transmission:
simply it waits one clock without checking the
slave acknowledging, and sends the new data.
This approach of course is less protected from
misworking.
TDA7466
7/21