MAX4751 Maxim, MAX4751 Datasheet
MAX4751
Available stocks
Related parts for MAX4751
MAX4751 Summary of contents
Page 1
... ON ON (max) R flatness. The digital input is 1.8V CMOS ON compatible when using a single +3V supply. The MAX4751 has four normally open (NO) switches, the MAX4752 has four normally closed (NC) switches, and the MAX4753 has two NO and two NC switches. The MAX4751/MAX4752/MAX4753 are available in ✕ 3mm 3mm, 16-pin QFN and 14-pin TSSOP packages. ...
Page 2
... TSSOP (derate 9.1W/°C above +70°C) ............727mW 16-Pin QFN (derate 16.9W/°C above +70°C) ............1349mW Note 1: Signals on COM_, NO_, or NC_ exceeding V+ or GND are clamped by internal diodes. Limit forward diode current to maximum current rating. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied ...
Page 3
Low-Voltage, Single-Supply Quad SPST ELECTRICAL CHARACTERISTICS—Single +3V Supply (continued) (V+ = +2.7V to +3.6V +1.4V +25°C.) (Notes PARAMETER SYMBOL SWITCH DYNAMIC CHARACTERISTICS Turn-On Time Turn-Off Time Break-Before-Make (Note 8) ...
Page 4
... Note 5: ∆ ON(MAX) ON(MIN) Note 6: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the specified analog signal ranges. Note 7: Leakage parameters are 100% tested at the maximum-rated hot operating temperature and guaranteed by correlation +25°C. A Note 8: Guaranteed by design, not production tested. ...
Page 5
... TEMPERATURE (°C) 100 1000 Analog Switches TURN-ON/TURN-OFF TIME vs. SUPPLY VOLTAGE OFF 2.7 3.0 1.6 2.0 2.4 2.8 SUPPLY VOLTAGE (V) CHARGE INJECTION vs 1. 0.3 0.6 0.9 1.2 1.5 1.8 V (V) COM LOGIC THRESHOLD vs. SUPPLY VOLTAGE 1.1 1.0 0.9 RISING 0.8 FALLING 0.7 0.6 0.5 1.6 1.8 2.0 2.2 2.4 2.6 2.8 3.0 3.2 3.4 3.6 V+ (V) MAX4751 3.2 3.6 COM 2.1 2.4 2.7 3.0 5 ...
Page 6
... T = +25°C, unless otherwise noted.) A TOTAL HARMONIC DISTORTION vs. FREQUENCY 0.034 0.032 0.030 0.028 0.026 0.024 0.022 0.020 1 10 100 1k FREQUENCY (Hz) PIN MAX4751 MAX4752 TSSOP QFN TSSOP QFN 1, 3, 15, 1, — 15, 1, — — — — ...
Page 7
... Low-Voltage, Single-Supply Quad SPST V+ V+ NO_ MAX4751 IN_ COM_ GND NC_ NO_ NC_ MAX4753 IN_ COM_ GND Figure1. Switching Times _______________________________________________________________________________________ Test Circuits/Timing Diagrams NO_ IN_ NO_ COM_ V COM_ 50Ω 0 35pF NO_ IN_ NO_ ...
Page 8
... NO_ OR NC_ * MAX4751 V OUT MAX4752 MEAS MAX4753 COM_ IN_ GND 50Ω OFF-ISOLATION = 20log ON-LOSS = 20log *ADD 50Ω TERMINATION FOR OFF-ISOLATION V+ V+ NO_ OR NC_ 1MHz MAX4751 CAPACITANCE MAX4752 ANALYZER IN_ MAX4753 COM_ GND NETWORK 50Ω REF 50Ω V OUT OUT V IN ...
Page 9
... Low-Voltage, Single-Supply Quad SPST Detailed Description The MAX4751/MAX4752/MAX4753 are low 0.9Ω max ( 3V) on-resistance, low-voltage quad analog switches that operate from a +1.6V to +3.6V single sup- ply. CMOS construction allows switching analog signals that are within the supply voltage range (GND to V+). ...
Page 10
... Low-Voltage, Single-Supply Quad SPST Analog Switches Pin Configurations/Functional Diagrams/Truth Tables (continued) TOP VIEW NO2 COM2 MAX4751 N. IN2 9 QFN MAX4751 INPUT SWITCH STATE LOW OFF HIGH ON 10 ______________________________________________________________________________________ IN4 NC2 NO4 COM2 MAX4752 N.C. N. COM4 IN2 ...
Page 11
... Low-Voltage, Single-Supply Quad SPST (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) ______________________________________________________________________________________ Analog Switches Package Information 11 ...
Page 12
... Low-Voltage, Single-Supply Quad SPST Analog Switches (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 12 ______________________________________________________________________________________ Package Information (continued) ...
Page 13
... For the latest package outline information www.maxim-ic.com/packages.) Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...