TLE 7240SL Infineon Technologies, TLE 7240SL Datasheet - Page 11

• Manufacturer Part Number: TLE 7240SL
• Manufacturer: Infineon Technologies

Specifications of TLE 7240SL

• Packages: PG-SSOP-24
• Channels: 8.0
• Rds (on) (typ): 1.5 Ohm
• Vdd: 3.0 - 5.5 V
• Vds(cl): 41.0 - 52.0 V

5
The SPIDER - TLE 7240SL is a eight channel low-side relay switch.
The power stages are built by N-channel vertical power MOSFET transistors.
5.1
The SPIDER - TLE 7240SL is supplied by two power supply lines
The digital power supply line
supply
There are power-on reset functions implemented for both supply lines. After start-up of the power supply, all SPI
registers are reset to their default values and the device is in idle mode. Capacitors at pins
GND are recommended.
There is a reset pin available. Low level at this pin causes all registers to be set to their default values and the
quiescent supply currents are minimized.
5.1.1
The SPIDER - TLE 7240SL offers the capability of driving dedicated channels during eventual fail-safe operation
of the system. This limp home mode is activated by a high signal at pin LHI. In this mode, the SPI registers are
reset and the input pins are directly routed to their corresponding channels OUT1 to OUT4, see
OUT5 to OUT8 are turned off in limp home mode. Furthermore, the SPI is ignored and all input pin are referred to
V
A high signal on LHI overrides a Reset signal on RST. In case of a limp home during standby the device will
therefore wake up and enter the limp home mode.
After limp home operation all registers are reset and the device enters in standby mode following low logic RST
state, or returns to idle (all channels OFF). Next SPI transmission will receive a TER Flag.
IN1
IN2
IN3
IN4
Table 2
5.2
There are four input pins available at SPIDER - TLE 7240SL, which can be configured to be used for control of
the output stages. The INn parameter of the SPI selects the input pin to be used.
of SPIDER - TLE 7240SL.
During Limp home mode a default routing is switched and the SPI commands are ignored.
Data Sheet
Input
DDA
in order to ensure a defined operation mode if the digital supply or the microcontroller fail.
V
DDA
supports 5 V supply.
Input and Power Stages
Power Supply
Limp Home Mode
Routing during limp home mode
Input Circuit
V
DD
is designed to be functional at a very wide voltage range. The analog power
11
controlled
Output
OUT1
OUT2
OUT3
OUT4
SPI Driver for Enhanced Relay Control
V
DD
and
V
DDA
.
Figure 4
SPIDER - TLE 7240SL
Input and Power Stages
shows the input circuit
Rev. 1.4, 2011-10-21
V
DD
Table 2
-GND and
for details.
V
DDA
-