LM048V2 LM TECHNOLOGIES, LM048V2 Datasheet - Page 11

• Manufacturer Part Number: LM048V2
• Manufacturer: LM TECHNOLOGIES

7.7 7 wire configuration (Tx, Rx, GND, RTS, CTS, DTR, DSR)
7.8 AT Command Set
Set 7 wire configuration by sending AT+FLOW+ and AT+MODEMR
and adapter. DTR, DSR lines are used for handshaking between local
device and remote connected device. The DTR, DSR line status is
transmitted wirelessly over bluetooth link
For all settings refer section 7.9
The following is the AT command set for the local adapter in the
command mode (that is, the local adapter is in the disconnection state).
All the commands and parameters are case insensitive.
Please note “AT+FIND?” command is available only when the adapter is
in the manual master role. In other words, you should send “AT+ROLEM”,
“AT+ACON-” before sending “AT+FIND? command“
command. RTS, CTS lines are used for local flow control between device
8