A2175-HBL ETC, A2175-HBL Datasheet - Page 8

• Manufacturer Part Number: A2175-HBL
• Description: Specification FOR Approval
• Manufacturer: ETC

建準電機工業股份有限公司
建準電機工業股份有限公司
建準電機工業股份有限公司
建準電機工業股份有限公司
SUNONWEALTH ELECTRIC
MACHINE INDUSTRY CO., LTD.
10.While the fan is in operation, please do not lock the fan intentionally for a long period of
11.During the installation of the fan, please pay substantial attention to possible noise
12.
13.Unless otherwise specified, if there is any doubt in the judgement, the temperature and
1. SUNON will not guarantee the products if the application of our products is exceeded
5. If there is any data or related documentation different from this data sheet, this data
9. Please do not store the fan in the environment of high / low temperature, high humidity
2. In case of change of the specification specified on this document, a written notice is
3. Please do not touch the impeller with pressure and never bring the fan with lead wire.
4. No guarantee on the products against the safety problem or failure caused by powder
6. For the purpose of MIS, please indicate SPEC No. on every order.
7. In case of the fan has no polarity protection function, wires with same color (electrode)
8. Please do not use the fan in the environment of corrosive gas or liquid or any detrimental
Notes
During the testing of the fan, please be sure to use finger guard to insure safety.
the limitation which is specified on this specification.
requested in advance.
The bearings and lead wire may be damaged.
dust, drop of water or insect.
sheet is the principal reference.
must be connected together during the assembly. (i.e. red + red, black + black)
or the fan will be damaged immediately.
gas.
or any detrimental gas. Please store the fan within 6 months, every 6 months, there
shall be a leakage of electric current to the fan, even though the fan is stored in room
temperature.
time, since the continuous stoppage will result in over-heat and damage of the fan.
cause by resonance vibration and vibration.
relative humidity range of environment will be take in according to the standard test
condition as 25 ℃ ℃ ℃ ℃ and 65%.
ISSUE DATE 06. 22. 2001 E D I T I O N
SPEC. NO.
P A G E
7 OF 7
A170028
REVISE DATE
SUNON
0