SL1710 Mitel Networks Corporation, SL1710 Datasheet - Page 3

• Manufacturer Part Number: SL1710
• Description: Quadrature Downconverter
• Manufacturer: Mitel Networks Corporation

ELECTRICAL CHARACTERISTICS (continued)
They apply within the specified ambient temperature and supply voltage unless otherwise stated.
Notes:
1. The choice of L will have an effect on phase noise of the VCO
2. Target value at fo=500MHz, L (tank)=10nH, Q (tank, unloaded)=50, SSB
DESCRIPTION
high linearity, low noise digital satellite applications. It contains
all the elements necessary, with the exception of the VCO
tuning components, to extract baseband I and Q signals from
a QPSK or QAM IF input signal.
is fed via a SAW filter, centred at the standard IF of 479.5MHz.
A filtered single channel is therefore presented to the device,
at a typical level of -51dBV. An AGC is included with 18dB of
gain control, which is guaranteed to provide an overall conver-
sion gain between 30 and 45dB from the RF input to the I and
Q outputs.
Prescaler sidebands
Power supply rejection
T amb = 0
The SL1710 is a quadrature downconverter, intended for
A block diagram for the SL1710 is shown in Fig. 2.
In normal consumer digital satellite applications, the device
Characteristic
o
C to 80
o
C, V ee = 0V, Vcc = 4.75 to 5.25 V, These characteristics are guaranteed by either production test or design.
2, 7
2, 7
Pin
Min
25
Value
Typ
-50
30
which is centred on the incoming IF. The oscillator external
tuning network should be fully symmetric, to ensure optimum
gain and phase match.
a 760mV (p/p) signal, assuming a nominal -51dBV input signal
and 40dB gain, suitable for driving a dual channel ADC such as
the PCA 869, PCA 913 and PCA 916 via an anti-alias filter (see
application notes). The ADC is normally AC coupled via two
capacitors (typically 4.7 F).
These may be fed to an external PLL circuit which can be used
to drive the on-chip oscillator, thus forming a complete control
loop.
The quadrature mixers are fed from an on-chip oscillator
Single ended I and Q amplifiers are provided, which output
The SL1710 also includes divide by 32 prescaler output.
The VCO can be disabled by applying 0V to pin 15.
Max
-47
Units
dBV
dB
Measured in IQ outputs
Attenuation VCC to IQ outputs,
over 0-500kHz
Conditions
SL1710
3