ds2505pt-r Maxim Integrated Products, Inc., ds2505pt-r Datasheet - Page 19

no-image

ds2505pt-r

Manufacturer Part Number
ds2505pt-r
Description
Ds2505 16-kbit Add-only Memory
Manufacturer
Maxim Integrated Products, Inc.
Datasheet
(Figure 11) should be applied for 480 µs, after which the bus master returns the data line to an idle high
state controlled by the pullup resistor. Note that due to the high voltage programming requirements for
any 1-Wire EPROM device, it is not possible to multidrop non-EPROM based 1-Wire devices with the
DS2505 during programming. An internal diode within the non-EPROM based 1-Wire devices will
attempt to clamp the data line at approximately 8 volts and could potentially damage these devices.
INITIALIZATION PROCEDURE “RESET AND PRESENCE PULSES” Figure 9
* In order not to mask interrupt signaling by other devices on the 1-Wire bus, t
READ/WRITE TIMING DIAGRAM Figure 10
less than 960 µs.
RESISTOR
MASTER
19 of 24
RSTL
+ t
R
should always be

Related parts for ds2505pt-r