lm25011myx National Semiconductor Corporation, lm25011myx Datasheet - Page 11

no-image

lm25011myx

Manufacturer Part Number
lm25011myx
Description
42v, 2a Constant On-time Switching Regulator With Adjustable Current Limit
Manufacturer
National Semiconductor Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
LM25011MYX
Manufacturer:
TI/德州仪器
Quantity:
20 000
Part Number:
lm25011myx/NOPB
Manufacturer:
NSC
Quantity:
13 450
Part Number:
lm25011myx/NOPB
0
Company:
Part Number:
lm25011myx/NOPB
Quantity:
14 000
Ripple Requirements
The LM25011 requires a minimum of 10 mVp-p ripple voltage
at the CS pin. That ripple voltage is generated by the de-
creasing recirculating current (the inductor’s ripple current)
through R
The ripple voltage is equal to:
where ΔI is the inductor current ripple amplitude, and R
the current sense resistor at the CS pin.
N-Channel Buck Switch and Driver
The LM25011 integrates an N-Channel buck switch and as-
sociated floating high voltage gate driver. The gate driver
circuit works in conjunction with an external bootstrap capac-
itor (C
pacitor connected between BST and SW provides the supply
voltage for the driver during the on-time. During each off-time,
the SW pin is at approximately -1V, and C
BST
) and an internal high voltage diode. A 0.1 µF ca-
S
during the off-time. See Figure 3.
FIGURE 3. CS Pin Waveform
V
RIPPLE
= ΔI x R
S
FIGURE 2. Normal and Current Limit Operation
BST
is recharged
30094625
S
is
11
from the internal 5V regulator for the next on-time. The mini-
mum off-time ensures a sufficient time each cycle to recharge
the bootstrap capacitor.
Soft-Start
The soft-start feature allows the converter to gradually reach
a steady state operating point, thereby reducing startup
stresses and current surges. Upon turn-on, when V
its under-voltage lock-out threshold an internal 10 µA current
source charges the external capacitor at the SS pin to 2.51V
(t1 in Figure 1). The ramping voltage at SS ramps the non-
inverting input of the regulation comparator, and the output
voltage, in a controlled manner. For proper operation, the soft-
start capacitor should be no smaller than 1000 pF.
The LM25011 can be employed as a tracking regulator by
applying the controlling voltage to the SS pin. The regulator’s
output voltage tracks the applied voltage, gained up by the
ratio of the feedback resistors. The applied voltage at the SS
pin must be within the range of 0.5V to 2.6V. The absolute
maximum rating for the SS pin is 3.0V. If the tracking function
causes the voltage at the FB pin to go below the thresholds
for the PGD pin, the PGD pin will switch low (see the Power
Good Output section). An internal switch grounds the SS pin
if the input voltage at VIN is below its under-voltage lock-out
threshold or if the Thermal Shutdown activates. If the tracking
function (described above) is used, the tracking voltage ap-
plied to the SS pin must be current limited to a maximum of 1
mA.
Shutdown Function
The SS pin can be used to shutdown the LM25011 by ground-
ing the SS pin as shown in Figure 4. Releasing the pin allows
normal operation to resume.
www.national.com
30094624
IN
reaches

Related parts for lm25011myx