tmp88ps38ng TOSHIBA Semiconductor CORPORATION, tmp88ps38ng Datasheet - Page 8

• Manufacturer Part Number: tmp88ps38ng
• Description: Cmos 8-bit Microcontroller
• Manufacturer: TOSHIBA Semiconductor CORPORATION

1.4
Writing Method for General-purpose PROM Program
(1) Adapters
(2) PROM programmer specifying
(3) Writing
operating procedure.
i)
ii) Data transfer (copy) (Note 1)
iii) Writing address is specified. (Note 1)
Note 1: The specifying method is referred to the PROM programmer description. Either write the
Note 2: When MCU is set to an adapter or the adapter is set to PROM programmer, a position of
BM11174A: TMP88PS38N
BM11175A: TMP88PS38F
Writing/Verifying is required to be executed in accordance with PROM programmer
PROM type is specified to TC571000D. (Note 1)
storage area) and 0A000H to 0FFFFH (OSD font area) and 1FF00H to 1FFFFH (Vector
table storage area). Data is required to be transferred (Copied) to the addresses where
it is possible to write. The program area in MCU mode and PROM mode is referred to
“Program memory area” in Figure 1.1.
Writing voltage: 12.75 V (High-speed programming mode)
In the TMP88PS38, EPROM is within the addresses 10000H to 1FEFFH (Program
Start address:0A000H
End address: 1FFFFH
data FFH to the unused area or set the PROM programmer to access only the program
storage area.
pin 1 must be adjusted. If the setting is reversed, MCU, the adapter and PROM program
is damaged.
88PS38-8
TMP88PS38
2005-05-18