e5gn-rtcac100-240 ETC-unknow, e5gn-rtcac100-240 Datasheet - Page 18

• Manufacturer Part Number: e5gn-rtcac100-240
• Description: Digital Temperature Controllers
• Manufacturer: ETC-unknow

4. Avoid using the Controller in places near a radio, television set, or
Mounting
1. Insert the E5GN into the mounting hole in the panel from the
2. Push the adapter along the E5GN body from the terminals up to
3. Tighten the two fixing screws on the adapter. When tightening
Removing and Attaching the Terminal Plate
The E5GN can be replaced by removing the terminal plate.
1. Press down hard on the fasteners on both sides of the terminals
2. Draw out the terminal plate as it is.
3. Before you insert the terminal plate again, make sure that the pins
18
wireless installing. These devices can cause radio disturbances
which adversely affect the performance of the Controller.
front.
the panel, and secure it temporarily.
screws, tighten the two screws alternately keeping the torque to
within approximately 0.29 to 0.39 N·m.
to unlock the terminal plate and pull upwards.
match the positions of the holes in the terminal plate.
Digital Temperature Controllers
Adapter
Waterproof packing
E5GN
Panel
Wiring Precautions
• Connect the terminals as specified below.
• The exposed current-carrying part to be inserted into terminals
• Tighten the terminal screws to the torque specified below.
1 to 6
7 to 9
1 to 6
7 to 9
must be 5 to 6 mm.
Terminal No.
Terminal No.
Electrical wire
5 to 6 mm
M2.6
M2
AWG24 to AWG14
AWG28 to AWG22
Screw
Cables
0.23 to 0.25 N·m
0.12 to 0.14 N·m
Pin terminal
Maximum tightening
2.1 dia. max.
1.3 dia. max.
Pin terminals
5 to 6 mm
torque