pd104vt2 AZ Displays, Inc, pd104vt2 Datasheet - Page 18

• Manufacturer Part Number: pd104vt2
• Description: Color Tft Lcd Module
• Manufacturer: AZ Displays, Inc

10.
The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be
distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,
Ltd.
10-1) Mounting of module
10-2) Precautions in mounting
10-3) Adjusting module
10-4) Others
10-5) Polorizer mark
Handling Cautions
a) Please power off the module when you connect the input/output connector.
b) Please connect the ground pattern of the inverter circuit surely. If the connection
c) Polarizer which is made of soft material and susceptible to flaw must be
d) Protective film (Laminator) is applied on surface to protect it against scratches
a) When metal part of the TFT-LCD module (shielding lid and rear case) is soiled,
b) Wipe off water drops or finger grease immediately. Long contact with water may
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or bumped on
d) Since CMOS LSI is used in the module. So take care of static electricity and
a) Adjusting volumes on the rear face of the module have been set optimally before
b) Therefore, do not change any adjusted values. If adjusted values are changed, the
a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many
b) Store the module at a room temperature place.
c) The voltage of beginning electric discharge may over the normal voltage because of
d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.
e) Observe all other precautionary requirements in handling general electronic
f) Please adjust the voltage of common electrode as material of attachment by 1 module.
The polorizer mark is to describe the direction of wide view angle film how to mach
up with the rubbing direction.
1.The noise from the backlight unit will increase.
2.The output from inverter circuit will be unstable.
3. In some cases a part of module will heat.
handled carefully.
and dirts. It is recommended to peel off the laminator before use and taking
care of static electricity.
wipe it with soft dry cloth.
cause discoloration or spots.
hard surface. Please handle with care.
earth yourself when handling.
shipment.
specifications described may not be satisfied.
hours.
leakage current from approach conductor by to draw lump read lead line around.
Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes or feet.
Wash it out immediately with soap.
components.
is not perfect, some following problems may happen possibly.
PD104VT2
Page:18