ilx506 Sony Electronics, ilx506 Datasheet - Page 13

• Manufacturer Part Number: ilx506
• Description: 5000-pixel Ccd Linear Image Sensor B/w
• Manufacturer: Sony Electronics

Notes on Handling
1) Static charge prevention
2) Regulation for raising and lowering the power supply voltage
3) Soldering
4) Dust and dirt protection
5) Exposure to high temperatures or humidity will affect the characteristics.
6) CCD image sensors are precise optical equipment that should not be subject to mechanical shocks.
CCD image sensors are easily damaged by static discharge. Before handling be sure to take the following
protective measures.
a) Either handle bare handed or use non chargeable gloves, clothes or material. Also use conductive shoes.
b) When handling directly use an earth band.
c) Install a conductive mat on the floor or working table to prevent the generation of static electricity.
d) Ionized air is recommended for discharge when handling CCD image sensor.
e) For the shipment of mounted substrates, use boxes treated for the prevention of static charges.
When raising the supply voltage, first raise V
Similarly, lower V
a) Make sure the package temperature does not exceed 80°C.
b) Solder dipping in a mounting furnace causes damage to the glass and other defects. Use a grounded 30W
c) To dismount an image sensor, do not use a solder suction equipment.
a) Operate in clean environments.
b) Do not either touch glass plates by hand or have any object come in contact with glass surfaces. Should
c) Clean with a cotton bud and ethyl alcohol if the grease stained.
d) Keep in a case to protect from dust and dirt. To prevent dew condensation, preheat or precool when
Accordingly avoid storage or usage in such conditions.
soldering iron and solder each pin in less than 2 seconds. For repairs and remount, cool sufficienty.
When using an electric desoldering tool, ground the controller. For the control system, use a zero cross
type.
dirt stick to a glass surface, blow it off with an air blower. (For dirt stuck through static electricity ionized
air is recommended.)
Be careful not to scratch the glass.
moving to a room with great temperature differences.
DD2
(5V) first and then V
DD1
DD1
(9V).
(9V) and then V
– 13 –
DD2
(5V).
ILX506