m37280eksp Mitsumi Electronics, Corp., m37280eksp Datasheet - Page 101

• Manufacturer Part Number: m37280eksp
• Description: Single-chip 8-bit Cmos Microcomputer With Closed Caption Decoder And On-screen Display Controller
• Manufacturer: Mitsumi Electronics, Corp.

12.11.11 Multiline Display
This microcomputer can ordinarily display 16 lines on the CRT screen
by displaying 16 blocks at different vertical positions. In addition, it
can display up to 16 lines by using OSD interrupts.
An OSD interrupt request occurs at the point at which display of each
block has been completed. In other words, when a scanning line
reaches the point of the display position (specified by the vertical
position registers) of a certain block, the character display of that
block starts, and an interrupt occurs at the point at which the scan-
ning line exceeds the block. The mode in which an OSD interrupt
occurs is different depending on the setting of the OSD control regis-
ter 2 (refer to Figure 12.11.7).
• When bit 7 of the OSD control register 2 is “0”
• When bit 7 of the OSD control register 2 is “1”
Fig. 12.11.36 Note on Occurence of OSD Interrupt
Rev. 1.0
An OSD interrupt request occurs at the completion of layer 1 block
display.
An OSD interrupt request occurs at the completion of layer 2 block
display.
On display (OSD interrupt request occurs
at the end of block display)
Block 1 (on display)
Block 2 (on display)
Block 3 (on display)
Block 4 (on display)
Block 1
Block 2
(B)
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
No
“OSD interrupt request”
“OSD interrupt request”
“OSD interrupt request”
“OSD interrupt request”
“OSD interrupt request”
“OSD interrupt request”
M37280MF–XXXSP, M37280MK–XXXSP
(A)
Window
x x x x x x
x x x x x x
x x x x x x
x x x x x x
x x x x x x
Off display (OSD interrupt request does
not occur at the end of block display)
Notes 1: An OSD interrupt does not occur at the end of display when the block
2: When another block display appeares while one block is displayed,
3: On the screen setting window, an OSD interrupt occurs even at the
Block 1 (on display)
Block 2 (on display)
Block 3 (off display)
Block 4 (off display)
is not displayed. In other words, if a block is set to off display by the
display control bit of the block control register i (addresses 00D0
00DF
12.11.36 (A)).
an OSD interrupt request occurs only once at the end of the another
block display (refer to Figure 12.11.36 (B)).
end of the CC mode block (off display) out of window (refer to Figure
12.11.36 (C)).
Block 1
Block 2
Block 3
16
), an OSD interrupt request does not occur (refer to Figure
(C)
and ON-SCREEN DISPLAY CONTROLLER
MITSUBISHI MICROCOMPUTERS
“OSD interrupt request”
“OSD interrupt request”
No
“OSD interrupt request”
No
“OSD interrupt request”
“OSD interrupt request”
“OSD interrupt request”
“OSD interrupt request”
M37280EKSP
16
101
to