DS32KHZ-N/DIP DALLAS [Dallas Semiconductor], DS32KHZ-N/DIP Datasheet

Page 1

... No Calibration Required § Low-Power Consumption § Surface Mountable Using BGA Package § UL Recognized ORDERING INFORMATION PART DS32kHz/DIP DS32kHz-N/DIP DS32kHz/WBGA DS32kHz-N/WBGA DS32kHz Crystal Oscillator Operating Voltage: 2.7V to 5.5V with V Operating Voltage: 4.5V to 5.5V TEMP RANGE 0ºC to +70ºC -40ºC to +85ºC 0ºC to +70ºC -40º ...

Page 2

ABSOLUTE MAXIMUM RATINGS Voltage Range on Any Pin Relative to Ground Operating Temperature Range Commercial Industrial Storage Temperature Range Soldering Temperature (BGA) Soldering Temperature, Leads (DIP) Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the ...

Page 3

AC TIMING CHARACTERISTICS (Over the operating range, unless otherwise specified.) PARAMETER Output Frequency Frequency Stability vs. Temperature Duty Cycle Cycle Time High/Low Time Rise Time Fall Time Oscillator Startup Time Frequency Stability vs. Operating Voltage Crystal Aging Note 8: These ...

Page 4

TYPICAL OPERATING CHARACTERISTICS (V = 3.3V +25° ∞ C, unless otherwise noted vs. V BAT BAT 4.5 4.0 3.5 3.0 2.5 2.0 1.5 2.5 3.0 3.5 4.0 4.5 V (V) BAT FREQUENCY ERROR vs. V ...

Page 5

... Figure 1. Delta Time and Frequency vs. Temperature FUNCTIONAL DESCRIPTION The DS32kHz requires four pins for operation: V schemes.) Power is applied through V of power. The output is accurate to ±7.5ppm (±4 min/yr) from –40°C to +85°C and ±2ppm (±1 min/yr) from 0°C to +40°C. ...

Page 6

... OPERATION The DS32kHz module contains a crystal and an IC. While powered, the DS32kHz peridocially measures the temperature and adjusts the crystal load to compensate. The DS32kHz is designed to operate in two modes. In the dual-supply mode, a comparator circuit, powered by V monitors the relationship between the the device switches over to V ...

Page 7

... RTC as well. Figure 5 shows one circuit that BAT can be used to reduce the current consumption of a DS32kHz and an RTC. The values of R1 and C1 may vary depending on the RTC used. However, values of 1.0MW and 100pF are recommended as a starting point used to shift the input waveform to the proper level ...

Page 8

... RELATED APPLICATION NOTES Application Note 58: Crystal Considerations with Dallas Real-Time Clocks Application Note 701: Using the DS32kHz with Dallas RTCs PACKAGE INFORMATION (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package information www ...

Page 9

PACKAGE INFORMATION (continued) (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package information www.maxim-ic.com/DallasPackInfo ...

Page 10

PACKAGE INFORMATION (continued) (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package information www.maxim-ic.com/DallasPackInfo.) PKG 14-PIN DIP DIM MIN A IN 0.825 B IN 0.420 C IN 0.235 D ...