MC44BC374T1D FREESCALE [Freescale Semiconductor, Inc], MC44BC374T1D Datasheet - Page 15

• Manufacturer Part Number: MC44BC374T1D
• Description: PLL Tuned PAL/NTSC UHF and VHF Audio/Video High Integration Modulator IC
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Video Black Level
Audio signal: 50Hz to 15KHz, 100mV
This is measured using a Rohde &
Schwarz AMFS Demodulator in B/G and
a HP8903A.
Audio: 1Khz, adjustable level
Video Black Level
This is measured using a Rohde &
Schwarz AMFS UHF Demodulator in B/G
and a HP8903A Audio Analyzer at 1kHz.
The output level of the Audio analyzer is
varied to obtain a deviation of 50kHz
indicated on the Demodulator.
Audio: 1Khz, adjustable level
Video: EBU Color Bars
This is measured using a Rohde &
Schwarz AMFS Demodulator in B/G and
a HP8903A Audio Analyzer at 1kHz. The
output level of the Audio analyzer is
varied to obtain a Modulation Deviation
of 25kHz indicated on the AMFS
Demodulator.
Device and Signals Set-up
Freescale Semiconductor, Inc.
For More Information On This Product,
rms
MC44BC374T1 Technical Data
The audio signal 1KHz 100mV
demodulated by the Demodulator and the audio analyzer measures the
AC amplitude of this demodulated audio signal: this value is taken as a
reference (0dB).
The audio signal is then swept from 50Hz to 15KHz, and demodulated
AC amplitude is measured in dB relative to the 1KHz reference.
Audio pre-emphasis and de-emphasis circuits are engaged, all audio
analyzer filters are switched OFF.
The input rms detector of the Audio Analyzer converts the ac level of the
combined signal + noise + distortion to dc. It then removes the
fundamental signal (1kHz) after having measured the frequency. The
output rms detector converts the residual noise + distortion to dc. The dc
voltmeter measures both dc signals and calculates the ratio in% of the
two signals.
The Audio Analyzer alternately turns ON and OFF it's internal audio
source to make a measure of the Audio signal plus noise and then
another measure of only the noise.
The measurement is made using the internal CCIR468-2 Filter of the
Audio Analyzer together with the internal 30+/-2kHz (60dB/decade)
Lowpass filters.
The AMFS demodulator uses a quasi-parallel demodulation as is the
case in a normal TV set. In this mode the Nyquist filter is bypassed and
the video carrier is used without added delay to effectuate intercarrier
conversion. In this mode the phase noise information fully cancels out
and the true S/N can be measured
Go to: www.freescale.com
Audio Frequency response
Audio Signal to Noise
Audio Distortion FM
ADist
=
ASN dB
(
Distorsion
(
)
=
Characterization Measurement Conditions
Measurement Set-up
20
+
×
Noise
rms
log
(
is supplied by the Audio Analyzer,
Signal
)
⁄
(
Distorsion
+
Noise
+
)
⁄
Noise
(
Noise
+
)
Signal
)