SC411EVB SEMTECH [Semtech Corporation], SC411EVB Datasheet - Page 20

• Manufacturer Part Number: SC411EVB
• Description: Synchronous Buck Pseudo-Fixed Frequency Power Supply Controller
• Manufacturer: SEMTECH [Semtech Corporation]

SC411
POWER MANAGEMENT
Figure 9: Power Component Placement and Copper Pours
Key points for the power section:
1) There should be a very small input loop, well decoupled.
2) The phase node should be a large copper pour, but compact since this is the noisiest node.
3) Input power ground and output power ground should not connect directly, but through the ground planes instead.
4) The current limit resistor should be placed as close as possible to the ILIM and LX pins.
Connecting the control and power sections should be accomplished as follows (see Figure 10 on the following page):
1) Route VOUT in a “quiet” layer away from noise sources.
2) Route DL, DH and LX (low side FET gate drive, high side FET gate drive and phase node) to chip using wide traces
with multiple vias if using more than one layer. These connections to be as short as possible for loop minimization,
with a length to width ratio less than 20:1 to minimize impedance. DL is the most critical gate drive, with power ground
as its return path. LX is the noisiest node in the circuit, switching between VBAT and ground at high frequencies, thus
should be kept as short as practical. DH has LX as its return path.
3) BST is also a noisy node and should be kept as short as possible.
4) Connect PGND and VSSA directly to the thermal pad, and connect the thermal pad to the ground plane using mul-
tiple vias.
© 2007 Semtech Corp.
20
www.semtech.com