UPD62A NEC, UPD62A Datasheet - Page 21

• Manufacturer Part Number: UPD62A
• Description: 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
• Manufacturer: NEC

4.3 Carrier Output
register 0.
to be output until its next fall and then stops due to the function of the carrier synchronous circuit. When the timer
starts operation, however, the high-level width of the first carrier may be shorter than the specified width.
4.4 Software Control of Timer Output
instruction cycle (64/f
The carrier for remote-controlled transmission can be output from the REM pin by clearing (to 0) bit 2 of control
Notes 1. Error when the REM output ends: Lead by “the carrier’s low-level width” to lag by “the carrier’s high-
The timer output can be controlled by software. As shown in Figure 4-4, a pulse with a minimum width of 1-
As shown in Figure 4-3, in the case where the timer stops when the carrier is at a high level, the carrier continues
2. Error of the carrier’s high-level width: 0 to “the carrier’s high-level width”
level width”
LED
REM (at low-level start)
REM (at high-level start)
X
) can be output.
REM
MOV T, #0000000000B; low-level output from the REM pin
MOV T, #1000000000B; high-level output from the REM pin
MOV T, #0000000000B; low-level output from the REM pin
LED
Figure 4-4. Pulse Output of 1-Instruction Cycle Width
Figure 4-3. Timer Output (When Carrier Is Output)
Data Sheet U14474EJ1V0DS00
Note 2
Timer value: (Set value+1) 64/f
64/f
X
X
(or 128/f
X
Note 1
)
PD62A
21